Toro LT2240 Installation Instructions Manual

Models 31657 and 316591. Connect the main wire-harness connector tothe control arm that you disconnected in 3Removing the Existing Seat (page 6).2. Locate the connector labeled AIR-RIDE on theseat behind the rubber boot.Locate the air-ride seat connector on the mainwire harness breakout and install the connector.Note: The breakout of the main wire harnessis located by the seat.3. Connect the seat-switch connector.4. Remove the fuse-block cover located next to thebattery (Figure 29)g328464Figure 291. Fuse block 2. Fuse-block cover5. Install the new mini fuse (10 A) into the fuseblock (Figure 29).Note: Use the decal on the fuse-block cover forthe fuse position.6. Install the fuse-block cover (Figure 29).20