Toro Groundsmaster 3200 Series Operator's Manual

Also see for 3200: Operator's manual Operator's manual Operator's manual Operator's manual Installation instructions

Checking the Lubricant inthe GearboxService Interval: Every 50 hoursAfter the first 50 hoursEvery 400 hoursThe gearbox in designed to operate on SAE 80-90weight gear lube. Although the gearbox comes withlubricant from the factory, check the level beforeoperating the cutting unit. The gearbox capacity is283 ml (15 fl oz).1. Park the machine on a level surface, lower thecutting unit, engage the parking brake, shut offthe engine, and remove the key.2. Remove the dipstick/fill plug from the top ofthe gearbox (Figure 17) and ensure that thelubricant is between the marks on the dipstick. Ifthe lubricant level is low, add enough lubricantuntil the level is between the marks.g010548Figure 171. Dipstick/fill plug3. Install the dipstick and torque it to 9 N∙m (84in-lbs).Checking the Torque of thePTO Driveshaft-to-GearboxFastenersService Interval: After the first 10 hoursEvery 100 hoursCheck the torque of the fasteners that secure thePTO driveshaft to the gearbox (Figure 18); refer to thesetup section in your machine Operator’s Manual forthe appropriate torque specification.g299646Figure 181. Gearbox 3. PTO driveshaft2. Bolts and nutsRemoving the Cutting Unitfrom the Traction Unit1. Park the machine on a level surface with thecutting unit raised.2. Remove the height-of-cut pins (Figure 19) fromthe cutting-unit side plates.g296784Figure 191. Height-of-cut chain 2. Pin3. Lower the cutting unit, engage the parkingbrake, shut off the engine, and remove the key.4. Remove the bolts and washers that secure thelift arms to the castor arms.19