Toro Greensmaster TriFlex 3320 Installation Instructions Manual

Also see for Greensmaster 3420 TriFlex: Manual Service manual Operator's manual Operator's manual Operator's manual

Form No. 3394-595 Rev AE-Reels Harness KitGreensmaster® 3320 or 3420 TriFlex® Traction UnitModel No. 131-8758Installation InstructionsWARNINGCALIFORNIAProposition 65 WarningThis product contains a chemical or chemicals known to the State of California tocause cancer, birth defects, or reproductive harm.Note: Determine the left and right and front and back sides of the machine from the normal operating position.Preparing the Machine1. Park the machine on a level surface, stop the engine,and remove the key from the ignition.2. Disconnect the negative battery cable from the battery.3. Disable the reel batteries by pulling apart the batterydisconnect at the base of the left side of the ROPS.4. Remove the flange-head bolts securing the left andright side consoles, and remove the consoles.Note: Retain the flange-head bolts and the leftconsole. Discard the right console.Figure 1Right console shown1. Flange-head bolts 2. Right console5. Tip the seat forward.6. Remove the ground terminal connectors (J06 and J08)from the ground block.7. Cut and remove all the cable ties securing the existingwiring harness.Important: Do not cut any wires or othercomponents.8. Remove the mounting bracket that holds the fuse blockunder the seat.Note: Keep the fuse block attached to the bracket.Figure 21. Flange bolts (remove andretain)3. Fuse block2. Bracket 4. Harness bracket9. Disconnect the harness from the 3 reel motors (2connectors each).© 2015—The Toro® Company8111 Lyndale Avenue SouthBloomington, MN 55420Register at www.Toro.com. Original Instructions (EN)Printed in the USAAll Rights Reserved *3394-595* A