Toro Cab Kit Operator's Manual

Also see for 07142: Operator's manual

7Routing the Wire HarnessParts needed for this procedure:1 Fuse block2 Hex-washer head screw (#10 x 3/4 inch)—for 2019and after electric machines only2 Serrated nut (#10)—for 2019 and after electricmachines only2 Self-tapping screw—for 2019 and after gasolinemachines only1 Fuse (15 A)For Electric MachinesImportant: The Power Converter Kit is requiredto use the cab on a Workman GTX Electric utilityvehicle. Contact your authorized Toro distributorfor more information.1. Install the new fuse block as follows:• For 2018 and before machines, snap thenew fuse block onto the existing fuse blockon the machine (Figure 17).g035257Figure 171. To ground 3. To the optional washerpump kit2. To the fused wire 4. New fuse block• For 2019 and after machines, secure thenew fuse block using the 2 hex-washer headscrews (#10 x 3/4 inch) and 2 serrated nuts(#10) as shown in Figure 18.g290937Figure 181. New fuse block 3. Serrated nut (#10)2. Hex-washer head screw(#10 x 3/4 inch)4. Female connector2. For 2019 and after machines, connect thefemale connector on the harness to the newfuse block (Figure 18).3. Connect the large connector on the new fuseblock to the optional power cable on the existingfuse block (Figure 17).12