Toro CM-658H-S Operator's Manual

Also see for 68004: Operator's manual Operator's manual

Preparing the Machine for Towing1. Shut-off the engine and fuel valve.2. Empty the drum.3. Using the handwheel, position the drum so that itis pointing down toward the ground (Figure 16).g019806Figure 161. Drum pointing down 3. Tow pole bolted in place2. Drum-tilt brake engaged4. Lock the drum into position by pushing down thedrum-tilt-brake handle (Figure 17).g019733Figure 17Drum-Tilt Brake1. Unlocked position 2. Locked position5. Close the engine cowl and secure the cowllatches (Figure 18).g019741Figure 186. Inspect the tires; refer to Inspecting the Tires(page 37).Raising the Stabilizer LegsEnd-Dump Models OnlyEnd-dump models have a front stabilizer leg and 2rear stabilizer legs.Raise the stabilizer legs before towing the machine.1. Adjust the machine so that there is no weightresting on the rear stabilizer legs.2. Pull the clevis pin out from 1 of the rear stabilizerlegs and the bracket (Figure 19).g019917Figure 1917