Menu
Toro ACME Installation Instructions Manual
  |
The ACME thread golf sprinkler body requires an ACME thread swing joint for connection to the piping system. The ACME swingjoint has an o-ring on the exit fitting that provides a watertight seal inside the sprinkler body when properly assembled.With the ACME fitting, it is important to note that thread sealants such as TeflonTM tape or pipe dope are not required andshould not be used during assembly.Important! For ease of assembly and to ensure proper sealing, moisten the o-ring with clean water just prior to installation.To Install full-circle sprinklers:Screw the sprinkler body clockwise onto the ACME swing joint exit fitting until itstops. No further tightening is required.To Install part-circle sprinklers:Screw the sprinkler body clockwise onto the ACME swing joint exit fitting until itstops. If necessary, adjust the left (fixed) side of the sprinkler arc by turning the bodycounterclockwise up to 3⁄4 turn.Caution: Leakage between the swing joint exit fitting and the sprinkler bodymay indicate that the o-ring is improperly seated, missing, damaged and/or thesprinkler body is not completely installed.If leakage is observed, perform the following procedure:1. Shut off and relieve system water pressure.2. Remove the sprinkler from the swing joint fitting.3. Verify that the o-ring is undamaged and is properly seated in the o-ring groove.(Replace the o-ring if necessary.)4. Moisten the o-ring with water, reinstall the sprinkler, repressurize the system andcheck for leakage.ACME Thread Installation InstructionsSprinkler BodyACME ThreadSwing JointExit FittingForm Number 371-0049 Rev. A©1998 The Toro Company, Irrigation DivisionO-RingThe ACME thread golf sprinkler body requires an ACME thread swing joint for connection to the piping system. The ACME swingjoint has an o-ring on the exit fitting that provides a watertight seal inside the sprinkler body when properly assembled.With the ACME fitting, it is important to note that thread sealants such as TeflonTM tape or pipe dope are not required andshould not be used during assembly.Important! For ease of assembly and to ensure proper sealing, moisten the o-ring with clean water just prior to installation.To Install full-circle sprinklers:Screw the sprinkler body clockwise onto the ACME swing joint exit fitting until itstops. No further tightening is required.To Install part-circle sprinklers:Screw the sprinkler body clockwise onto the ACME swing joint exit fitting until itstops. If necessary, adjust the left (fixed) side of the sprinkler arc by turning the bodycounterclockwise up to 3⁄4 turn.Caution: Leakage between the swing joint exit fitting and the sprinkler bodymay indicate that the o-ring is improperly seated, missing, damaged and/or thesprinkler body is not completely installed.If leakage is observed, perform the following procedure:1. Shut off and relieve system water pressure.2. Remove the sprinkler from the swing joint fitting.3. Verify that the o-ring is undamaged and is properly seated in the o-ring groove.(Replace the o-ring if necessary.)4. Moisten the o-ring with water, reinstall the sprinkler, repressurize the system andcheck for leakage.ACME Thread Installation InstructionsSprinkler BodyACME ThreadSwing JointExit FittingForm Number 371-0049 Rev. A©1998 The Toro Company, Irrigation DivisionO-Ring |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved