Toro 74590 Operator's Manual

Also see for 190-DH: Installation instructions Operator's manual Operator's manual

27Replacing the FuseThe electrical system is protected by fuses. They arelocated beneath the hood, near the fuel tank (Fig. 24). If afuse goes out, check the circuit wiring for a short.1 2 34m-498655Figure 241. Main/ battery2. Headlights3. Interlock, electric clutch,and cruise control4. Full bag buzzer5. Extra fuseTo replace a fuse, pull up to remove it from the socket.Push down to insert it.• Main/ Battery—15 amp• Headlights—10 amp• Interlock, electric clutch, and cruise control—10 amp• Full bag buzzer—5 ampServicing the HeadlightsSpecification: Bulb # 1156, automotive typeRemoving the Bulb1. Disengage the blades (PTO).2. Set the parking brake.3. Stop the engine and wait for all moving parts to stop.4. Remove the ignition key.5. Open the hood.6. Disconnect the wire connectors from both of the bulbholder terminals.7. Rotate the bulb holder 1/4 turn counterclockwise andremove it from the reflector (Fig. 25).123445 51874Figure 251. Bulb holder2. Reflector3. Tabs4. Slots5. Terminals8. Push and rotate the bulb counterclockwise about 1/4turn until it stops and remove the bulb from the bulbholder (Fig. 26).1234241875Figure 261. Bulb2. Metal pins3. Bulb holder4. SlotsInstalling the Bulb1. Align the metal pins on the base of the bulb with theslots in the bulb holder and insert the base into theholder (Fig. 26).2. Push and rotate the bulb clockwise until it stops.3. Align the tabs on the bulb holder (Fig. 25) with the slotsin the reflector.4. Insert the bulb holder into the reflector and rotate it 1/4turn clockwise until it stops.5. Connect the wire connectors to the terminals on thebulb holder.