Toro 72200 Operator's Manual

292. Stop the engine, remove the key, and wait for allmoving parts to stop before leaving the operatingposition.3. Open the hood. Pull wire connectors off both bulbholder terminals.4. Rotate the bulb holder 1/4 turn counterclockwise andremove it from the reflector (Fig. 30).5. Push and rotate the bulb counterclockwise until it stops(approx. 1/4 turn) and remove bulb from the bulbholder (Fig. 31).123445 5Figure 301. Bulb holder2. Reflector3. Tabs4. Slots5. TerminalsInstalling the Bulb1. The bulb has metal pins on the side of its base. Alignthe pins with the slots in the bulb holder and insert thebase into the holder (Fig. 31). Push and rotate the bulbclockwise until it stops.123424Figure 311. Bulb2. Metal pins3. Bulb holder4. Slots2. The bulb holder has two tabs (Fig. 30). Align the tabswith the slots in the reflector, insert the bulb holderinto the reflector and rotate it 1/4 turn clockwise untilit stops.3. Push the wire connectors onto the terminals on thebulb holder.Servicing the BatteryCALIFORNIAProposition 65 WarningBattery posts, terminals, and related accessoriescontain lead and lead compounds, chemicalsknown to the State of California to cause cancerand reproductive harm. Wash hands afterhandling.WarningService Interval/SpecificationAlways keep the battery clean and fully charged. Use apaper towel to clean the battery case. If the batteryterminals are corroded, clean them with a solution of fourparts water and one part baking soda. Apply a lightcoating of grease to the battery terminals to preventcorrosion.Voltage: 12 v, 260 Cold Cranking Amps