Toro 72051 Operator's Manual

Also see for 265H Wheel Horse: Operator's manual Service manual Operator's manual Operator's manual

30Servicing the Transaxle FluidService Interval/SpecificationThe transaxle is a sealed system and no checking orchanging of the fluid is required.Important If any transaxle problems arise, contactyour local Authorized Service Dealer for help and service.Servicing the FuseService Interval/SpecificationThe electrical system is protected by fuses. It requires nomaintenance, however, if a fuse blows checkcomponent/circuit for malfunction or short. To replacefuses pull up on the fuse (Fig. 33) to remove or replace it.Fuse: Main/Starter F1—30 amp, blade-typeAlternator F2—25 amp, blade-typeDash/Hour meter F3—10 amp, blade-typeHead lights F4—10 amp, blade-type23441234Figure 331. Main—30 amp2. Alternator—25 amp3. Dash/Hour meter—10Amp4. Head lights—10 ampServicing the HeadlightsSpecification: Bulb No. 1156 Automotive TypeRemoving the Bulb1. Disengage the power take off (PTO), set the parkingbrake, and turn the ignition key to off. Remove theignition key.2. Open the hood. Pull wire connectors off both bulbholder terminals.3. Rotate the bulb holder 1/4 turn counterclockwise andremove it from the reflector (Fig. 34).4. Push and rotate the bulb counterclockwise until it stops(approx. 1/4 turn) and remove bulb from the bulbholder (Fig. 35).123445 5Figure 341. Bulb holder2. Reflector3. Tabs4. Slots5. TerminalsInstalling the Bulb1. The bulb has metal pins on the side of its base. Alignthe pins with the slots in the bulb holder and insert thebase into the holder (Fig. 35). Push and rotate the bulbclockwise until it stops.123424Figure 351. Bulb2. Metal pins3. Bulb holder4. Slots2. The bulb holder has two tabs (Fig. 34). Align the tabswith the slots in the reflector, insert the bulb holderinto the reflector and rotate it 1/4 turn clockwise untilit stops.