Toro 51930 Operator's Manual

Also see for 51930: Operator's manual

Operation 17Starting the ProductSee Figure 14a, Figure 14b, and Figure 15.Starting the product differs depending on whether theengine is cold or warm. Refer to the label on the air filtercover.To Start a Cold EngineFollow these steps to start a cold engine.1. Lay the product on a flat, bare surface.2. Toggle the switch to the I (ON) position.3. Push the primer bulb approximately eight times.4. Set the choke lever to A (Choke Closed).5. Press the lock-off button and squeeze the trigger.6. Pull the starter cord three times.7. Set the choke lever to B (Choke Open).8. Press the lock-off button and squeeze the trigger.9. Pull the starter cord.Note: If the product starts, let it run for 30 secondsbefore using it. If the product does not start, repeatthe previous steps.Figure 14aFigure 14bTo Start a Warm EngineFollow these steps to start a warm engine.1. Lay the product on a flat, bare surface.2. Toggle the switch to the I (ON) position.3. Push the primer bulb up to eight times.4. Set the choke lever to B (Choke Open).5. Do not squeeze the trigger.6. Pull the starter cord.Note: If the product does not start, repeat the previ-ous steps.Stopping the ProductSee Figure 15.Follow these steps to stop the product.1. Release the trigger.2. Toggle the switch to the O (OFF) position.Figure 15WARNING:The product may throw objects duringoperation, causing injury to the operator or tobystanders. Always wear suitable eye protection,long heavy pants, and boots while operating theproduct.BulbPrimerLock-offButtonTriggerStarterCordSwitchSet Choke to A Set Choke to BSwitchTrigger