Toro 38518 Operator's Manual

Also see for 38518: Operator's manual

Contents

Figure 66. Tighten the knobs until they are snug.7. Adjust the control cable. Refer to Adjusting the ControlCable.2. Installing the DischargeChuteInstall the discharge chute as shown (Figure 7).Figure 73. Installing the Chute Crank1. Insert the end of the chute crank through the hole inthe shroud and align the mounting bracket with theholes in the lower handle (Figure 8).Figure 81. Chute crank 3. Mounting bracket2. Hole in the shroud 4. Plastic bushing2. Slowly rotate the crank until the end of the chute crankfits into the hidden gear opening and the dischargechute turns the crank.Note: Ensure that the plastic bushing is fully insertedinto the hole in the mounting bracket (Figure 8).3. Secure the mounting bracket to the handle with 2 boltsand 2 locknuts.7