Toro 22318 Operator's Manual

Also see for 22318: Service manual Operator's manual Operator's manual Operator's manual

SpecificationsNote: Specifications and design are subject to changewithout notice.Width 40.5 inches (103 cm)Length 60 inches (152 cm)Height 49 inches (125 cm)Weight (without attachment orcounterweight)1567 lb (711 Kg)Weight of the counterweight 180 lb (81.6 Kg)Operating capacity (with 200 lb operator,the standard bucket, and without thecounterweight)515 lb (234 Kg)Tipping capacity (with 200 lb operator,the standard bucket, and without thecounterweight)1030 lb (467 Kg)Wheelbase 28 inches (71 cm)Dump height (with standard bucket) 47 inches (120 cm)Reach—fully raised (with standardbucket)26 inches (66 cm)Height to hinge pin (narrow bucket instandard position)66 inches (168 cm)Attachments/AccessoriesA selection of Toro approved attachments andaccessories are available for use with the machine toenhance and expand its capabilities. Contact yourAuthorized Service Dealer or Distributor or go towww.Toro.com for a list of all approved attachmentsand accessories.Important: Use only Toro approved attachments.Other attachments may create an unsafe operatingenvironment or damage the traction unit.Stability DataThe following tables list the maximum slope recommended for the traction unit in the positions listed in the tables.Slopes over the listed degree may cause the traction unit to become unstable. The data in the tables assume that theloader arms are fully lowered; raised arms may affect the stability.In each attachment manual is a set of three stability ratings, one for each hill position. To determine the maximumslope you can traverse with the attachment installed, find the degree of slope that corresponds to the stability ratingsof the attachment. Example: If the attachment has a Front Uphill rating of B, a Rear Uphill rating of D, and aSide Uphill rating of C, then you could drive forward up an 20° slope, rearward up a 10° slope, or sideways on a13° slope, as listed in the following table.Maximum Recommended Slope whenOperating with:Front Uphill Rear Uphill Side UphillConfigurationTraction unit without attachment 10° 20° 18°Traction unit with counterweight, without attachment 8° 20° 19°Traction unit with an attachment rated with one of the following stability ratingsfor each slope position:*A 25° 25° 20°B 20° 20° 17°C 15° 15° 13°D 10° 10° 9°E 5° 5° 5°13