Toro 136-1199 Installation Instructions Manual

Form No. 3407-721 Rev ABrake Replacement KitTwister® or Workman® Utility VehicleModel No. 136-1199Installation InstructionsWARNINGCALIFORNIAProposition 65 WarningThis product contains a chemical or chemicals known to the State of California tocause cancer, birth defects, or reproductive harm.InstallationLoose PartsUse the chart below to verify that all parts have been shipped.Procedure Description Qty. Use1 No parts required – Prepare the machine.2 No parts required – Remove the existing brake assembly.Right spindle 1Left spindle 1Brake-caliper assembly 2Flange-head bolt (3/8 x 1 inch) 4Rotor 2Hex-socket bolt (5/16 x 3/4 inch) 8Front brake-line assembly 1Banjo washer 4Banjo bolt 2Clip 23Bleed screw 2Install the new brake assembly.4 No parts required – Bleed the brake calipers.5 No parts required – Install the wheels.6 No parts required – Adjust the front wheel toe-in.7 No parts required – Burnish (break-in) the brakes.© 2016—The Toro® Company8111 Lyndale Avenue SouthBloomington, MN 55420Register at www.Toro.com. Original Instructions (EN)Printed in the USAAll Rights Reserved *3407-721* A