Toro 07253TC Operator's Manual

Also see for Workman 2100: Service bulletin Operator's manual Operator's manual Operator's manual Operator's manual

FusesThere are three fuses in the machine’s electricalsystem. They are located beneath the bed in a box onthe right hand side of the frame (Fig. 33).Fuses: Ignition System—10 amp.Lights—10 amp.Power Point—10 amp. (15 amp. max.)Figure 331. Ignition system2. Lights3. Power point4. OpenReplacing the HeadlightsSpecification: GE Headlight # H76101. Set the parking brake, turn the ignition off, andremove the key.2. Reach beneath the dash and push the headlight outof the hood.3. Remove the screws attaching the wire harness tothe headlight.4. Remove the rubber seal from around the headlight(Fig. 34). Discard the headlight.5. Align the notch on the inside of the seal with thenotch on the new headlight (Fig. 34). Slide theseal onto the headlight until the seal is firmly inplace.Figure 341. Rubber seal2. Inside notch—align with notch on headlight3. Outside notch align with notch in hood4. Headlight6. Attach the headlight to the wire harness using thepreviously removed screws.7. Align the notch on the outside of the seal with thenotch in the hood. Push the headlight and seal intothe hood until it is firmly in place.Note: Applying soapy water to the outside of theseal may aid in sliding the seal into the hood.Servicing the BatteryDo not jump start the vehicle.Service Interval/SpecificationAlways keep the battery clean and fully charged. Usea paper towel to clean the battery and battery box. Ifthe battery terminals are corroded, clean them with asolution of four parts water and one part baking soda.Apply a light coating of grease to the battery terminalsto prevent corrosion.Important312 3Battery posts, terminals, and related accessoriescontain lead and lead compounds, chemicals knownto the State of California to cause cancer andreproductive harm. Wash hands after handling.WARNING2

/ 33

Related manuals for Toro Workman 2100