Toro 04357 Operator's Manual

Also see for Greensmaster 3150: Operator's manual Operator's manual Operator's manual Operator's manual Service manual

Contents

Reel Speed ControlUse the reel speed control (Figure 23) to adjust the RPMof the reel.SpecificationsNote: Specifications and design are subject to changewithout notice.Overall Width w/reels 69–3/4 inches (177 cm)Overall Length 90 inches (228.6 cm)Overall Height 48-1/2 inches (123.2 cm)Overall Weight with Reels 1256 lb (570 kg)Net Weight (dry) 969 lb (440 kg)Width of Cut 59 inches (149.9 cm)Wheel Tread 49-1/2 inches (125.7 cm)Wheel Base 46-7/8 inches (119.1 cm)Mow Speed (adjustable) 2–5 MPH approximately(3.2–8 km/h)Transport Speed 8.8 MPH approximately(14.1 km/h)Reverse Speed 2.5 MPH (4 km/h)Reel Speed 1975 RPM approximatelyAttachments/AccessoriesA selection of Toro approved attachments andaccessories are available for use with the machine toenhance and expand its capabilities. Contact yourAuthorized Service Dealer or Distributor or go towww.Toro.com for a list of all approved attachmentsand accessories.OperationNote: Determine the left and right sides of themachine from the normal operating position.Think Safety FirstPlease carefully read all of the safety instructionsand symbols in the safety section. Knowing thisinformation could help you or bystanders avoid injury.The use of protective equipment, such as but notlimited to, for eyes, ears, feet, and head is recommended.This machine produces sound levels in excessof 85dBA at the operator’s ear and can causehearing loss through extended periods ofexposure.Wear hearing protection when operating thismachine.Checking the Engine OilThe engine is shipped with 1-3/4 quarts (1.65 liters)(w/filter) of oil in the crankcase; however, the oil levelmust be checked before and after the engine is firststarted.The engine uses any high-quality detergent oil havingthe American Petroleum Institute (API) serviceclassification of SG, SH, or SJ or higher. Therecommended viscosity (weight) is SAE 30.1. Position the machine on a level surface.2. Unscrew the dipstick and wipe it with a clean rag.Screw the dipstick into the tube and make sure it isseated fully (Figure 24).Figure 241. Dipstick 2. Filler cap19