Teac W-890RMKII Owner's Manual

Teac W-890RMKII Owner's Manual Manual pdf 22 page image

22Timer-Controlled Playback and RecordingTimer-Controlled Playback1. Connect this unit and stereo system to a commerciallyavailable audio timer.2. Set the power switch of all components to ON.3. Load a prerecorded cassette tape in TAPE I or II.You can also insert tapes into both decks. In this case, TAPEI starts first.4. Set the REV MODE switch to the required position.If you set the REV MODE switch to 7:a tape deck plays only Side “A” of the tape.o If a tape is in both the TAPE I and TAPE II compartments, the TAPE Ideck plays Side “A” of the tape and then stops.If a tape is in the TAPE II compartment only, the TAPE II deckplays Side “A” of the tape.If you set the REV MODE switch to j:a tape deck continuously plays both sides of the tape.When the tape deck reaches the end of Side “A” in playback mode,it automatically reverses the tape and continues to play Side “B”.o If a tape is in both the TAPE I and TAPE II compartments, the TAPE Ideck plays both sides of the tape and then stops.If a tape is in the TAPE II compartment only, the TAPE II deckplays both sides of the tape.If you set the REV MODE switch to p:both sides of a tape are continuously played for up to five times.5. Set the TIMER switch to the PLAY position.6. Set the audio timer to the required start (power on) andstop (power off) times. When this setting is completed, thepower to all components will be switched off.When a preset start time is reached, power will be supplied andplayback will start automatically.Playback always starts from side “A”.NOTEo If you directly connect the deck’s AC power cord to the AC outlet,playback automatically starts by simply pressing on the POWERswitch of this deck when you set the TIMER switch to the PLAYposition. When you do not use the timer, set the TIMER switch tothe OFF position.Timer-controlled recording(Example: Recording a broadcast program)1. Connect this unit and stereo system to a commerciallyavailable audio timer.2. Set the power switch of all components to ON.3. Load a recordable cassette tape(s) in TAPE I or II (or bothdecks for continuous recording).4. Set the REV MODE switch to the required position.If you set the REV MODE switch to 7:a tape deck records on only Side “A” of the tape.o If a tape is in both the TAPE I and TAPE II compartments, theTAPE I deck records on Side “A” of the tape and then stops.If a tape is in the TAPE II compartment only, the TAPE II deckrecords on Side “A” of the tape.If you set the REV MODE switch to j:a tape deck continuously records on both sides of the tape.When the tape deck reaches the end of Side “A” in record mode,it automatically reverses the tape and continues to record on Side“B”.o If a tape is in both the TAPE I and TAPE II compartments, theTAPE I deck records on both sides of the tape and then stops.If a tape is in the TAPE II compartment only, the TAPE II deckrecords on both sides of the tape.If you set the REV MODE switch to p (continuous recording):insert a tape into both the TAPE I and TAPE II compartments. TheTAPE I and TAPE II decks continuously record on the tapes.