TC-Helicon Play Electric User Manual

Also see for Play Electric: Manual Quick start guide Quick start guide User manual

Contents

TC-Helicon Play Electric User Manual Manual pdf 62 page image

Mix button/sectionPlay Electric – Reference manual (2014-07-16) 60Press the MIX button to enter the Mix menu,where various audio signal levels within your PlayElectric can be adjusted.Mix page (1/2)Harmony parameterUse the Harmony parameter to control the over-all level of all voice-generating effect blocks likeHarmony and Double.Guitar Level parameterUse the Guitar Level parameter to adjust the out-put level of the guitar signal. This control is alsodependent on the Guitar input level, set in theSetup menu. Make sure to set your input levelaccording to the instructions and use the GuitarLevel parameter to set your “overall guitar outputvolume”.Out Level parameterUse the Out Level parameter to control the over-all output level of your Play Electric.Delay/Reverb level parameterUse the Delay/Reverb level parameter to changethe level of Delay/Reverb effects across all pre-sets.This control is useful if you find yourself in aperformance environment that has a lot (or verylittle) natural reverb and you’d like to “tune” yoursound to that room without having to manuallyadjust all presets.Headphone Level parameterUse the Headphone Level parameter to adjustthe volume of the headphone output.RoomSense parameterUse the RoomSense parameter to control theamount of ambient RoomSense sent to theheadphone mix. This parameter does NOT en-able RoomSense to be sent to the main mix, asthis would cause feedback.Aux Level parameterThe Aux Level parameter will only be shown if asignal source is connected to the Aux connector.Use the Aux Level parameter to adjust the levelof the signal received at the Aux input.If you prefer to only hear the Aux input over yourheadphones, go to the Setup/Output menu andchange “Aux to Main Out” to OFF.If you would like the Aux input to “listen” forchord information but not be heard at via theMain Out or Headphone outputs, set the AuxLevel parameter to OFF.