187Others• When you print images at a shop, images can be printed with the date if youask them to do so.The lens gets fogged.• Moisture condensation has occurred. Turn off the camera and leave it forabout an hour before using it (page 192).The message “Set Area/Date/Time.” appears when you turn on thecamera.• The camera has been left unused for sometime with a low battery or nobattery pack. Charge the battery pack and set the date again (pages 28, 192).If the date setting is lost every time the battery pack is charged, consult yourSony dealer or local authorized Sony service facility.The number of recordable images does not decrease or decreases two ata time.• This is because the compression rate and the image size after compressionchange depending on the image when you shoot a JPEG image (page 143).The setting is reset without the resetting operation.• The battery pack was removed when the power switch was set to ON. Whenremoving the battery pack, make sure the camera is turned off and theaccess lamp is not lit (pages 15, 20).The camera does not work properly.• Turn off the camera. Remove the battery pack and insert it again. If thecamera is hot, remove the battery pack, and allow it to cool down beforetrying this corrective procedure.• If an AC Adaptor (sold separately) is used, disconnect the power plug.Connect the power plug and turn on the camera again. If the camera doesnot work after doing these solutions, consult your Sony dealer or localauthorized Sony service facility.Others
