Sony WEGA KDL32XBR950, KDL42XBR950 Quick Start Manual

Also see for KDL-32XBR950 - 32" Flat Panel Lcd Wega™ Xbr Television: Supplementary guide Manual Limited warranty Instructions Specifications

Contents

tuning your tv

Quick Start Guide~ AC INi.LINK(TS/DV/MICROMV)DISPLAY SIGNAL OUTWHITE BLACKCABLEVHF/UHFS400IN OUTKDL32XBR950KDL42XBR950Thank you for purchasing thisSony product.After following this step by stepguide you will be able to:– Insert batteries into theremote control.– Connect the display unit tothe media receiver unit.– Connect a cable or antenna toyour TV.– Tune your TV .– Program your remote controlNow you are ready for viewingTV programs.© 2003 Sony CorporationPrinted in Japan 4-102-399-01(1)USChecking the SuppliedAccessories1Remote Control(RM-Y1000):Two size AAbatteries (R06 Type):Display InterfaceCable:Antenna Cable: Two AC powercords:Inserting Batteries intothe Remote Control21 Open the battery compartment as illustrated below.2 Insert two size AA batteries (supplied) by matching the e and Eterminals on the batteries to the diagram inside the batterycompartment.3 Close the battery compartment.Remove the batteries to avoid damage from possible battery leakagewhenever you anticipate that the remote control will not be used foran extended period.Handle the remote control with care.Avoid dropping it, getting it wet, placing it in direct sunlight, near aheater, or where the humidity is high.• Speaker jack covers(KDL42XBR950 only)• Operating Instructions• Quick Start Guide• Warranty CardConnecting theDisplay Unit to theMedia Receiver Unit31 Connect the display interface cable (supplied) to the DISPLAYSIGNAL IN jacks, and the AC power cord (supplied) to the AC IN jackof the unit.KDL42XBR9502 Connect the other end of display interface cable to the media receiverunit’s DISPLAY SIGNAL OUT jacks, and connect the media receiverunit’s AC power cord (supplied) to the AC IN jack .Tighten the screw slowlyuntil the screw is stabilized.Display Interface cable(supplied)KDL32XBR950When you install KDL42XBR950, use the optional accessories asfollows:• SONY TABLE TOP STAND: SU-P42T2• SONY WALL-MOUNT BRACKET: SU-PW2• SONY FLOATING STAND: SU-PF1Display Interfacecable (supplied)Tighten the screwslowly until thescrew is stabilized.AC power cord(supplied)BLACKWHITEDISPLAY SIGNAL INSONY EXCLUSIVE CABLE ONLYBe sure to use the supplied AC power cords.When connecting optional components, do not connect the ACpower cords to wall outlets until you have completed making allconnections.Do not tighten the screws too much. It may damage the screws.Do not use damaged cables, such as cables whose connectors aredeformed.Handle the display interface cable with care. This unit may fall andcause injury if accidently knocked or pulled by the connected cable.To store the AC power cord and the display interface cable in thestand;(KDL32XBR950)See “Storing the AC power cord and the display interface cableinto the stand (KDL32XBR950 only)” on page 28 of theoperating instructions.(KDL42XBR950)See the operating instructions for the optional tabletop stand.Connecting a Cable orAntenna4~ AC INi.LINK(TS/DV/MICROMV)DISPLAY SIGNAL OUTWHITE BLACKCABLEVHF/UHFS400The way in which you will connect your TV varies, depending on howyour home receives a signal (cable, cable box, antenna) and whether ornot you plan to connect a VCR or other optional AV equipment.See examples A, B or C to connect your TV. For details on otherconnection examples, see pages 31 to 54 of the operating instructions.ACable or AntennaFor best results, use this connection if you are connecting acable or an antenna and you;• Do not need a cable box to unscramble channels.• Do not intend to connect a VCR.For antenna connection, use the supplied antenna cable.BCable Box and CableFor best results, use this connection if;• Your cable company scrambles some channels, such as premiumchannels (which requires you to use a cable box), but does notscramble all channels.• You do not have a VCR.75-ohm coaxial cable(not supplied)When using an indoor antenna, such as rabbit-ear or dipole-antenna,keep the antenna away from the display unit. If not, noise may appearon the screen.Antenna cable(supplied)Rear of Media Receiver UnitCATVcable SplitterAntenna cable(supplied)Cable BoxRear of Media Receiver Unit75-ohmcoaxial cable(not supplied)75-ohmcoaxial cable(not supplied)or~ AC INi.LINK(TS/DV/MICROMV)DISPLAY SIGNAL OUTWHITE BLACKCABLEVHF/UHFS400AC power cord(supplied)

/ 2

Related manuals for Sony KDL-32XBR950 - 32" Flat Panel Lcd Wega™ Xbr Television