Sony UP-D897 Instructions For Use Manual

Also see for UP-D897: Specifications Instructions for use Service manual

Contents

OperationAdjustments and Settings Using the Menu 11a) The printing direction is as follows.b) These items can also be set on the printer driver side.When you place a check mark in a checkbox on the“Settings” tab of the printer driver, the settings madeon the printer side are enabled. When “CO:895” isselected in “COMD,” these items are not displayedand can not be set. When “CO:897” is selected, theseitems are disabled since the computer sends the printcommand to the printer until the printer completesprinting.c) The print direction of the images printed is as follows.Basic Menu OperationsThis section describes the basic menu operation whichare common to each menu, taking “How to set theprinting direction” as an example.1 Press the power ON/OFF switch to ON to turn theunit on.RSIZE b) To select whetheror not the imageis enlarged[RS:OFF]: Prints the imageat the original size.RS:ON: Prints the image ata larger size, according tothe paper size set by theprinter driver.BACK: Cancels the settingchange and returns to theitem selection column.SAVE To register up tothree kinds ofsettingsSA:3: Registers the menusettings as No.3.SA:2: Registers the menusettings as No.2.[SA:1]: Registers the menusettings as No.1.BACK: Cancels the settingchange and returns to theitem selection column.SHARP b) To adjust thesharpness of theprintoutYou can set the sharpness toany of 15 steps, from 0 to14.At a setting of 0, the outlineof the printout is notemphasized.A setting of step 2 is thefactory setting.BACK: Cancels the settingchange and returns to theitem selection column.SIDE c) To select thedirection in whichthe image is to beprintedS:SIDE: Prints the imagerotated by 90 degreescounterclockwise.[S:STD]: Prints the image inthe same direction as thatdisplayed on the monitor.BACK: Cancels the settingchange and returns to theitem selection column.SPEED(When“ME:HD” isselected in“MEDIA,”the printingspeed is fixedto “SP:NOR”and this itemis notdisplayed.)To select theprinting speedSP:NOR: Prints at thenormal speed.[SP:HI]: Prints at highspeed.BACK: Cancels the settingchange and returns to theitem selection column.NoteWhen “SP:HI” is selected,the power consumption is alittle higher, compared withprinting at the normalspeed.BACK To exit menumodeDisplay this item and thenpress the jog dial. The unitexits the menu mode and“READY” is displayed onthe LCD.Item Function SettingsWhen DI:NOR is selected When DI: REV is selectedImage displayed on the monitorPrintoutsWhen S:STD is selected. When S:SIDE is selected