Sony RDP-X50iP Operating Instructions Manual

Also see for RDP-X50iP: Specifications Operating instructions Operating instructions

WARNINGTo reduce the risk of fire or electric shock, do notexpose this apparatus to rain or moisture.To reduce the risk of fire, do not cover the ventilation ofthe apparatus with newspapers, tablecloths, curtains, etc.And do not place lighted candles on the apparatus.To reduce the risk of fire or electric shock, do not exposethis apparatus to dripping or splashing, and do not placeobjects filled with liquids, such as vases, on theapparatus.Do not install the appliance in a confined space, such asa bookcase or built-in cabinet.Do not expose the batteries (battery pack or batteriesinstalled) to excessive heat such as sunshine, fire or thelike for a long time.As the main plug is used to disconnect the unit from themains, connect the unit to an easily accessible AC outlet.Should you notice an abnormality in the unit, disconnectthe main plug from the AC outlet immediately.The unit is not disconnected from the AC power source(mains) as long as it is connected to the wall outlet, evenif the unit itself has been turned off.The nameplate and important information concerningsafety are located on the bottom exterior of main unitand on the surface of AC power adaptor.CAUTIONDanger of explosion if battery is incorrectly replaced.Replace only with the same type.Notice for customers: the following information isonly applicable to equipment sold in countriesapplying EU directivesThe manufacturer of this product is Sony Corporation,1-7-1 Konan Minato-ku Tokyo, 108-0075 Japan. TheAuthorized Representative for EMC and product safety isSony Deutschland GmbH, Hedelfinger Strasse 61, 70327Stuttgart, Germany. For any service or guarantee mattersplease refer to the addresses given in separate service orguarantee documents.The validity of the CE marking is restricted to only thosecountries where it is legally enforced, mainly in thecountries EEA (European Economic Area).FeaturesCompatible with iPod and iPhoneMEGA BASSAudio in functionWireless remote commander suppliedPrecautionsOperate the unit on the power source specified in“Specifications.”To disconnect the AC power cord (mains lead), pull itout by the plug, not the cord.Since a strong magnet is used for the speaker, keeppersonal credit cards using magnetic coding or spring-wound watches away from the unit to prevent possibledamage from the magnet.Do not leave the unit in a location near a heat sourcesuch as a radiator or airduct, or in a place subject todirect sunlight, excessive dust, mechanical vibration, orshock.Allow adequate air circulation to prevent internal heatbuild-up. Do not place the unit on a surface (a rug, ablanket, etc.) or near materials (a curtain) which mightblock the ventilation holes.Should any solid object or liquid fall into the unit,unplug the unit and have it checked by qualifiedpersonnel before operating it any further.To clean the casing, use a soft cloth dampened with amild detergent solution.If the unit is placed near a CRT-based TV or projector,ghosting may occur on its screen. In this case, move theunit away.NOTES ON LITHIUM BATTERYWipe the battery with a dry cloth to assure a goodcontact.Be sure to observe the correct polarity when installingthe battery.Do not hold the battery with metallic tweezers,otherwise a short-circuit may occur.Disposal of Old Electrical & ElectronicEquipment (Applicable in the EuropeanUnion and other European countrieswith separate collection systems)This symbol on the product or on its packaging indicatesthat this product shall not be treated as household waste.Instead it shall be handed over to the applicablecollection point for the recycling of electrical andelectronic equipment. By ensuring this product isdisposed of correctly, you will help prevent potentialnegative consequences for the environment and humanhealth, which could otherwise be caused byinappropriate waste handling of this product. Therecycling of materials will help to conserve naturalresources. For more detailed information about recyclingof this product, please contact your local Civic Office,your household waste disposal service or the shop whereyou purchased the product.Applicable accessory: Remote Commander.Disposal of waste batteries(applicable in the European Unionand other European countries withseparate collection systems)This symbol on the battery or on the packaging indicatesthat the battery provided with this product shall not betreated as household waste.On certain batteries this symbol might be used incombination with a chemical symbol. The chemicalsymbols for mercury (Hg) or lead (Pb) are added if thebattery contains more than 0.0005% mercury or 0.004%lead.By ensuring these batteries are disposed of correctly, youwill help prevent potentially negative consequences forthe environment and human health which couldotherwise be caused by inappropriate waste handling ofthe battery. The recycling of the materials will help toconserve natural resources.In case of products that for safety, performance or dataintegrity reasons require a permanent connection withan incorporated battery, this battery should be replacedby qualified service staff only.To ensure that the battery will be treated properly, handover the product at end-of-life to the applicablecollection point for the recycling of electrical andelectronic equipment.For all other batteries, please view the section on how toremove the battery from the product safely. Hand thebattery over to the applicable collection point for therecycling of waste batteries.For more detailed information about recycling of thisproduct or battery, please contact your local Civic Office,your household waste disposal service or the shop whereyou purchased the product.If you have any questions or problems concerning yourunit, please consult your nearest Sony dealer.Power sourcesPreparing a power source1 Connect the AC power cord (supplied) to the ACpower adaptor (supplied).2 Connect the AC power adaptor to the DC IN 20Vjack on the back of this unit firmly and plug it into awall outlet.AUDIO IN DC IN 20VAC poweradaptorAC powercordTo walloutletNote on the AC power adaptorUse the Sony supplied AC power adaptor only. The polarity of theplugs of other manufactures may be different. Failure to use thesupplied AC power adaptor may cause the unit to malfunction.Preparing the remotecommanderBefore using the remote commander for the first time,remove the insulation film.To know when to replace the batteryWith normal use, the battery (CR2025) should last forabout 6 months. When the remote commander no longeroperates the unit, replace the battery with a new one.with the + sidefacing upNotesDo not attempt to charge the battery.If you are not going to use the remote commander for a long time,remove the battery to avoid any damage that may be caused byleakage and corrosion.4-199-673-32(2)Personal AudioDocking System©2010 Sony Corporation Printed in ChinaRDP-X50iPOperating Instructions

/ 2

Related manuals for Sony RDP-X50iP