Sony PCM-7040 Operation Manual

Also see for 20001: Installation manual

Contents

Chapter 88-2 Chapter 8 Application SystemsNotes• “VIDEO” appears on the display when the videosync signal is input to this unit, and the setting of“rEF tcF” in the setup menu matches the sync signalfrequency. If the “VIDEO” indication on the displayis blinking, check the setting of the video sync signaland the time code format.• Set the time code format correctly by using “rEF tcF”in the setup menu. This unit does not automaticallydistinguish between the drop frame time code and thenon-drop frame time code.• Confirm the “SYNC PB” indication appears on thedisplay when this unit is playing back.BVE-9100/9000/2000/910/900/600 Video Editorsettings1 Set the TC SOURCE in the AUX mode to “LTC”,“LTC+”, “LTC:VITC” or “LTC:VITC+”.2 When using the following video editorBVE-900 (without BKE-900K): V1.11 or higherBVE-900 (with BKE-900K): V2.03 or higherBVE-910: V2.10 or higherBVE-2000BKE-9611/9004/9004A/9012 of the BVE-9000/9100: V2.01 or higherSet the device types BYTE 1 and 2 of block-1(CONSTANT-1) to “FF” (UNDEFINED). In thiscase, VTR CONFIGURATION is automaticallyset depending on the device type.When using BVE-600/900/910/9000/9100 editorsother than the models listed above.Set the following VTR constants.NTSC: When the setup menu “rEF-tcF” is set to“30ndF”, “29 97 ndF” or “29 97 dF”PAL: When the setup menu “rEF-tcF” is set to “25Ebu”Machine parameter groupDevice type00 96 05 05 03 803 4 5 6 7 800 96 05 05 03 801 2 3 4 5 6 7 8PCM-7040NTSCPCM-7040PALVTR Block-1 (CONSTANT-1) Block-2 (CONSTANT-2)70 00 0A 09 FF F6 00 5C FF 5A71 00 0A 09 FF F6 00 4C FF 4BSet the following machine parameters when thesoftware version of the BKE-9611/9004/9004A/9012of the BVE-9000/9100 is 2.00 or lower.Notes• You can use the first edit function of the video editor,when you set the setup menu “1St Edit” item to “on”and use a blank tape.• When this unit enters FF or REW mode, the timecode indication on the Video Editor may blink.Memory jog from video editorTo perform memory jog under control of the videoeditor, follow the procedure blow.When using the following BVE-910/2000/9100 videoeditor to control memory jogSoftware version with which memory jog can beperformed:BVE-910: V2.10 or higherBVE-9100:BKE-9101/9102: V1.04 or higherBKE-9611/9004/9004A/9102: V2.01 or higherSettings of this unit1 Set the setup menu “JoG ctL” item to “oFF”.2 Set the setup menu “StArt” item to “Edit-E” or“Edit-c”.1 2 3 4 5 6 7 8Block-4 (VTR CONFIGURATION)Machine parameter groupPCM-7040NTSC, PAL 01 00 88 71 03 7C 00 00VTR8-2 Systems with Editing Capability and Their Applications