Sony LMD-2451MT Instructions For Use Manual

Also see for LMD-2451MT: Brochure Instructions for use

Contents

Location and Function of Parts and Controls68k / (power) switchThe power is turned on or off.The monitor is turned on by pressing side .l PARALLEL REMOTE connector (modularconnector, 8-pin)Forms a parallel switch and controls the monitorexternally.When the unit is shipped from the factory, a connectorcover is attached to this connector. Remove it beforeusing the connector.For removing the connector cover, see page 71.For details on the pin assignment and factory settingfunction assigned to each pin, see page 92.CAUTIONFor safety, do not connect the connector for peripheraldevice wiring that might have excessive voltage to thisport. Follow the instructions for this port.m SERIAL REMOTE connector (RJ-45)Connect to the network by using a 10BASE-T/100BASE-TX LAN cable (shielded type, optional).When the unit is shipped from the factory, a connectorcover is attached to this connector. Remove it beforeusing the connector.For removing the connector cover, see page 71.For details on this connector, refer to the InterfaceManual for Programmers (saved in the supplied CD-ROM, Japanese and English only.)CAUTION• When an optional LAN cable is connected, use ashield type cable to prevent miss-operation due tonoises.• For safety, do not connect the connector for peripheraldevice wiring that might have excessive voltage to thisport. Follow the instructions for this port.• The connection speed may be affected by the networksystem. This unit does not guarantee thecommunication speed or quality of 10BASE-T/100BASE-TX.n SERIAL REMOTE RS-232C connector (D-sub9-pin, female)Connect to the RS-232C control connector on externalequipment connected to the monitor. The monitor canbe operated according to control commands sent fromexternal equipment connected to it.For details on the pin assignment and factory settingfunction assigned to each pin, see page 92.For details on this connector, refer to the InterfaceManual for Programmers (saved in the supplied CD-ROM, Japanese and English only.)o DVI-D input connector (DVI-D)Inputs DVI Rev.1.0 applicable digital RGB signal.To view the signals of the SXGA and higher resolutionwhen the DVI input is selected, use the cable within 3 m(118 1/8 inches) in length.p HD15 input connector (D-sub 15-pin, female)Inputs an analog RGB video signal (0.7 Vp-p, positivepolarity) and sync signal.The Plug & Play function corresponds to DDC2B.