Sony HVL-MT24AM Operating Instructions Manual

Also see for Alpha HVL-MT24AM: Brochure & specs Operating instructions Operating instructions Operating instructions

For customers in EuropeDisposal of Old Electrical & Electronic Equipment (Applicablein the European Union and other European countries withseparate collection systems)This symbol on the product or on its packaging indicates that thisproduct shall not be treated as household waste. Instead it shallbe handed over to the applicable collection point for the recyclingof electrical and electronic equipment. By ensuring this productis disposed of correctly, you will help prevent potential negativeconsequences for the environment and human health, which could otherwise becaused by inappropriate waste handling of this product. The recycling of materialswill help to conserve natural resources. For more detailed information aboutrecycling of this product, please contact your local Civic Office, your householdwaste disposal service or the shop where you purchased the product.< Notice for the customers in the countries applying EU Directives >The manufacturer of this product is Sony Corporation, 1-7-1 Konan Minato-kuTokyo, 108-0075 Japan. The Authorized Representative for EMC and product safetyis Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327 Stuttgart, Germany.For any service or guarantee matters please refer to the addresses given in separateservice or guarantee documents.For the customers in the U.S.A.CAUTIONYou are cautioned that any changes or modifications not expressly approved in thismanual could void your authority to operate this equipment.NOTE:This equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmfulinterference in a residential installation.This equipment generates, uses, and can radiate radio frequency energy and, ifnot installed and used in accordance with the instructions, may cause harmfulinterference to radio communications.However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or televisionreception, which can be determined by turning the equipment off and on, theuser is encouraged to try to correct the interference by one or more of followingmeasures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from that to whichthe receiver is connected.– Consult the dealer or an experienced radio/TV technician for help.