Sony HVL-F10 Operating Instructions Manual

Also see for HVL-F10: Operating instructions

 1998 by Sony Corporation Printed in JapanHVL-F10Video FlashOperating InstructionsMode d‘emploi3-862-667-11 (1)English FrançaisWARNINGTo prevent fire or shock hazard, do notexpose the unit to rain or moisture.To avoid electrical shock, do not open thecabinet. Refer servicing to qualifiedpersonnel only.This equipment has been tested and found to complywith the limits for a Class B digital device, pursuant toPart 15 of the FCC Rules. These limits are designed toprovide reasonable protection against harmfulinterference in a residential installation. This equipmentgenerates, uses, and can radiate radio frequency energyand, if not installed and used in accordance with theinstructions, may cause harmful interference to radiocommunications. However, there is no guarantee thatinterference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radioor television reception, which can be determined byturning the equipment off and on, the user is encouragedto try to correct the interference by one or more of thefollowing measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment andreceiver.– Connect the equipment into an outlet on a circuitdifferent from that to which the receiver is connected.– Consult the dealer or an experienced radio/TVtechnician for help.You are cautioned that any changes or modifications notexpressly approved in this manual could void yourauthority to operate this equipment.FeaturesYou can enjoy shooting subjects with the camcorderin photo mode under the following conditions:• Insufficient light• Too much brightness behind the subject (backlighting)CleaningRemove the video flash from the camcorder. Cleanthe video flash with a dry soft cloth.In case of stubborn stains, use a cloth lightlydampened with a mild detergent solution, then wipethe unit clean with a dry soft cloth.Never use strong solvents, such as thinner or benzine,as these damage the surface finish.IMPORTANTSAFETYINSTRUCTIONWhen using your electronic flash, basicsafety precautions should always befollowed, including the following:1 Read and understand all instructionsbefore using.2 Care must be taken as burns canoccur from touching hot parts.3 Do not operate appliance if it hasbeen dropped or damaged, until ithas been examined by a qualifiedserviceman.4 To reduce the risk of electric shock,do not immerse this appliance inwater or other liquids.3A5 To reduce the risk of electric shock,do not disassemble this appliance,but take it to a qualified servicemanwhen service or repair work isrequired. Incorrect reassembly cancause electric shock when theappliance is used subsequently.6 The use of an accessory attachmentnot recommended by themanufacturer may cause a risk offire, electric shock, or injury topersons.SAVE THESEINSTRUCTIONS12SpécificationsDimensions Environ 40×57×55,5 mm (1 9/16 ×2 1/ 4 × 2 3/ 16 pouces) (l/h/p)(Les saillies ne sont pas inclusesdans les dimensions)Poids Environ 90 g (3 1/ 5 on.)(batterie fournie comprise)Accessoires fournis Une batterie au lithium-manganèseCR123AUne housseLa conception et les spécifications sont modifiables sanspréavis.Cette marque indique que ceproduit est un accessoire prévu pourles produits vidéo Sony. Quand vousachetez un produit vidéo Sony, nousvous conseillons de vous procurerdes accessoires portant cette marque“GENUINE VIDEOACCESSORIES”.Installation des piles(Voir l’illustration A)1 Retirez le couvercle des piles.2 Installez les deux piles fournies.3 Replacez le couvercle.Remarques• Lorsque vous remplacez les piles, veillez à utiliser unebatterie au lithium-manganèse CR123A Sony neuve.• Placez les pôles positif (+) et négatif (–) des pilescorrectement, comme indiqué sur l’illustration.• Pour éviter tout dommage dû à une fuite d’électrolyte,enlevez les piles quand vous ne comptez pas utiliser leflash vidéo pendant un certain temps.TroubleshootingSymptomThe battery chargecomplete mark doesn’tappear in the viewfinder(or display window).The video flash does notwork even though thebattery charge completemark appears in theviewfinder.SpecificationsDimensions About 1 9/ 16 × 2 1/ 4 × 2 3/ 16 inches(About 40×57×55.5mm) (w/h/d)(Projections are not included in thedimensions)Mass About 3 1/5 oz. (90g)(including supplied battery)Supplied accessory One CR123A lithium manganesebattery.One pouch.Design and specifications are subject to change withoutnotice.This mark indicates that this product isa genuine accessory for Sony videoproducts. When purchasing Sony videoproducts, Sony recommends that youpurchase accessories with this“GENUINE VIDEO ACCESSORIES”mark.Installing the battery(See Figure A)1 Remove the battery cover.2 Install the two supplied batteries.3 Reattach the battery cover.Notes• When you replace the batteries, be sure to use one newSony CR123A lithium manganese battery. Use ofanother battery may present a risk of fire or explosion.• Set the positive (+) and negative (–) terminals of thebatteries correctly as illustrated.• To avoid damage from possible battery leakage,remove the batteries when you will not use the videoflash for a long time.WARNINGThe battery may explode if mistreated. Do not recharge,disassemble, or dispose of in fire.AVERTISSEMENTAfin d’éviter tout risque d’incendie oud’électrocution, ne pas exposer l’appareil à lapluie ou à l’humidité.Pour éviter tout risque de déchargeélectrique, n’ouvrez pas le boîtier. Ne confiezl’entretien qu’à un personnel qualifié.CaractéristiquesVotre caméscope autorise les prises de vue en modephoto dans les cas suivants:• Lumière insuffisante• Excès de luminosité derrière le sujet (contre-jour)NettoyageRetirez le flash vidéo du caméscope. Nettoyez le flashvidéo à l’aide d’un chiffon sec et doux.Si les taches persistent, utilisez un chiffon légèrementhumecté de savon liquide, puis essuyez à l’aide d’unchiffon doux et sec.N’utilisez jamais de solvants puissants tels quediluant ou benzine, car ils peuvent endommager lafinition externe.En cas de difficultésSymptômesLe témoin d’état de chargedes piles n’apparaît pasdans le viseur (ou dansl’afficheur).Le flash vidéo nefonctionne pas alors que letémoin de charge de labatterie apparaît dansle viseur.RemedyReplace the batterieswith one brand newSony lithiummanganese battery.Fresh batteries providepower for about 400flashes.You need to go to aSony dealer (Sonyservice facility) toreplace the bulb. Do notreplace the bulbyourself.RemèdesRemplacez les piles parune batterie au lithium-manganèse Sony neuve.Des piles neuvespermettent d’effectuerenviron 400 flashs.Consultez votredistributeur Sony(centre d’assistancetechnique Sony) pourremplacer l’ampoule.Ne remplacez pasl’ampoule vous-même.

/ 2

Related manuals for Sony HVL-F10