GB8About water-proof, dust-proof, andshock-proof performance of the cameraThis camera is equipped to be water-proof, dust-proof and shock-proof.Damage caused from misuse, abuse or failure to properly maintain the camerais not covered by the limited warranty.• This camera is water-proof/dust-proof equivalent to IEC60529 IP58. Thecamera is operable up to a water depth of 3 m for 60 minutes.• Do not directly subject the camera to flowing water such as tap water.• Do not use in hot springs.• Use the camera in the recommended operating water temperature range of–10°C to +40°C (14°F to 104°F).• Conforming to MIL-STD 810F Method 516.5-Shock standards, this producthas passed testing when dropped from a height of 1.5 m above a 5-cm thickplywood board*.* Depending on use conditions and circumstances, no guarantee is made regardingdamage to, malfunction of, or the water-proof performance of this camera.• As for dust-proof/shock-proof performance, there is no guarantee that thecamera will not become scratched or dented.• Sometimes water-proof performance is lost if the camera is subjected to astrong shock such as from being dropped. We recommend the camera beinspected at an authorized repair shop for a fee.• Accessories supplied do not meet water-proof, dust-proof, and shock-proofspecifications.Notes before using the camera under/near water• Make sure that no foreign matter such as sand, hair, or dirt gets inside thebattery/memory card cover or multi-connector cover. Even a small amountof foreign matter may lead to water entering the camera.• Confirm that the sealing gasket and itsmating surfaces have not become scratched.Even a small scratch may lead to waterentering the camera. If the sealing gasket orits mating surfaces become scratched, takethe camera to an authorized repair shop tohave the sealing gasket replaced for a fee.• If dirt or sand gets on the sealing gasket orits mating surfaces, wipe the area clean witha soft cloth that will not leave behind anyfibers. Do not use a sharp-pointedimplement to prevent the sealing gasket andits mating surfaces from becoming scratched.1 Sealing gasket2 Surface contacting thesealing gasket
