Sony DSC-T99 Instruction Manual

Also see for Cyber-shot DSC-T99D: Instruction manual Handbook Service manual Instruction manual Instruction manual

GB9GBFunctions built into this cameraThis manual describes each of the functions of TransferJet-compatible/incompatible devices.To check if your camera supports the TransferJet function, check for thefollowing mark on the bottom of the camera.TransferJet-compatible device: (TransferJet)On database filesWhen you insert a memory card without a database file into the camera andturn on the power, part of the memory card capacity is used to automaticallycreate a database file. It may take some time until you can perform the nextoperation.Notes on recording/playback• To ensure stable operations of the memory card, we recommend that you usethis camera to format any memory card being used with this camera for thefirst time. Note that formatting will erase all data recorded on the memorycard. This data cannot be restored. Be sure to backup any important data to aPC or other storage location.• Before you start recording, make a trial recording to make sure that thecamera is working correctly.• The camera is neither dust-proof, nor splash-proof, nor water-proof. Read“Precautions” (page 27) before operating the camera.• Avoid exposing the camera to water. If water enters inside the camera, amalfunction may occur. In some cases, the camera cannot be repaired.• Do not aim the camera at the sun or other bright light. It may cause themalfunction of the camera.• Do not use the camera near a location that generates strong radio waves oremits radiation. Otherwise, the camera may not properly record or play backimages.• Using the camera in sandy or dusty locations may cause malfunctions.• If moisture condensation occurs, remove it before using the camera.• Do not shake or strike the camera. It may cause a malfunction and you maynot be able to record images. Furthermore, the recording media may becomeunusable or image data may be damaged.• Clean the flash surface before use. The heat of flash emission may cause dirton the flash surface to become discolored or to stick to the flash surface,resulting in insufficient light emission.