Sony CRX320EE Product Information

Also see for CRX320AE: Product information

Contents

Safety RegulationsWARNINGYou are cautioned that any changes or modifications not expressly approved in this document could void yourauthority to operate this equipment.To prevent fire or shock hazard, do not expose the unit to rain or moisture.To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.CAUTION:As the laser beam in the CRX320AE is harmful to the eyes, do not attempt to disassemble the cabinet. Referservicing to qualified personnel only.The use of optical instruments with this product will increase eye hazard.The use of controls or adjustments or performance of procedures other than those specified herein may result inhazardous radiation exposure.This label is located on the top of the drive unit enclosure.Dieses Etikett befindet sich an der Oberseite des Laufwerksgehäuses.The CD-RW/DVD-ROM drive is classified as a CLASS 1 LASER PRODUCT.The CLASS 1 LASER PRODUCT label is located at the top of the enclosure.Bei diesem CD-RW/DVD-ROM-Laufwerk handeltes sich um ein Laser-Produkt der Klasse 1.Das Etikett mit der Aufschrift LASER KLASSE 1PRODUKT befindet sich auf der Oberseite desGehäuses.FCC Compliance:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant toPart 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, uses, and can radiate radio frequency energyand, if not installed and used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.Note:If you have any questions about this product, you may call the telephone number listed in the “Product andSupport Information” section. The telephone number below is not for customer service, but for officialpurposes only.Declaration of ConformityTrade Name: SONYModel No.: CRX320AEResponsible Party: Sony Electronics Inc.Address: 16450 W. Bernardo Dr., San Diego, CA 92127 U.S.A.Telephone No.: 858-942-2230This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference that may cause undesiredoperation.CE SicherheitsbestimmungenDiese Ausrüstung erfüllt die Europäischen EMC-Bestimmungen für die Verwendung in folgender / folgendenUmgebung(en):• Wohngegenden • Gewerbegebiete • Leichtindustriegebiete(Diese Ausrüstung erfüllt die Bestimmungen der Norm EN55022, Klasse B.)• Power-Burn and are trademarks of Sony Corporation.• Pentium is a registrated trademark of Intel Corporation.• Microsoft, MS, MS-DOS and Windows are registered trademarks of Microsoft Corporation.• Other system and product names used herein are registered trademarks or trademarks of their respectivemanufacturers, although the TM and ® marks are not used in the text.Before using this device, be sure to read the end-user license agreements for the software provided with yourcomputer.❑ Our product warranty is valid only when the supplied accessories (including software) are used in thespecified or recommended system environment, in accordance with the documentation, and appliesonly to the CD-RW/DVD-ROM drive. Our customer service and user support apply only under theseproduct warranty conditions.❑ Please note that we cannot accept responsibility for failure of the computer or other devices,incompatibility with special hardware, operating problems caused by improper installation of software,loss of data, discs or other accidental or incidental damage that might occur when using this product.❑ The guarantee and user support for this product are valid only within the countries or sales regionsspecified on the warranty card.❑ Copyright laws prohibit the copying in part or in full of the supplied software and documentation, orloaning the software, without obtaining permission of the copyright holder.❑ We cannot accept responsibility for any direct or indirect financial damage or loss of profit that mightoccur when using the supplied software.❑ The supplied software can only be used with this product.❑ Specifications of the supplied software may be changed without notice in the interest in productimprovement.LUOKAN 1 LASERLAITEKLASS 1 LASER APPARATCLASS 1LASER PRODUCTLASER KLASSE 1PRODUKT2-590-610-11(2)CRX320AECD-RW/DVD-ROMDrive 2005 Sony Corporation Printed in China P/N: 7819901067AProduct InformationIncluded Documents❑ Warranty card❑ Product Information (this document)Precautions for UseOperation and storage conditionsAvoid using or storing the drive in a hot or humid location, or where it might be subjectto severe vibration or direct sunlight.On transportationIf the drive is to be shipped while installed in a PC, remove any disc beforehand.Avoiding condensation problemsAs much as possible, avoid sudden temperature changes. Do not attempt to use the driveimmediately after moving it from a cold to a warm location, or raising the roomtemperature suddenly, as condensation may form within the drive. If the temperature changessuddenly while using the drive, stop using it but keep the power on for at least an hour.Handling discs• Handle discs only by the edges.Never touch the recording surface.• Do not store discs in dusty, dirty or humid locations, in direct sunlight, or nearheat-generating devices.• To protect important data, always keep discs in their protective cases.• Do not wipe writable discs to clean them before recording data. Instead, use a blower toremove any dust.• Data may not record properly if a scratch or dust is present on the unrecorded area of writablediscs. Use special care when handling.Emergency EjectIf the tray does not open with the Eject button, turn the PC off and insert a thin tool (such as astraightened paper clip) into this hole to eject the tray manually.• Do not affix labels on discs.About 40 mm (1.5 in)CAUTIONDepending on the product you are using, the Emergency Eject Hole may be in a different location than illustrated above.

/ 2

Related manuals for Sony CRX320AE