Sony CP-AD2 Operating Instructions Manual

CP-AD2 0904-310-02002US/ES/PT/CTCP-AD2 0904-310-02002US/ES/PT/CTChanges or modifications not expressly approved by the party responsible for compliance could void theuser’s authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may cause harmfulinterference to radio communications. However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Consult the dealer or an experienced radio/TV technician for help.EspañolFUENTE DE ALIMENTACIÓN Y ADAPTADOR USB PORTÁTILMODELO CP-AD2POR FAVOR LEA DETALLADAMENTE ESTE MANUAL DE INSTRUCCIONES ANTES DE CONECTAR YOPERAR ESTE EQUIPO.RECUERDE QUE EL MAL USO DE ESTE APARATO PODRIA ANULAR LA GARANTIA.Este producto puede utilizarse con las series CP-F/CP-V.Lea detenidamente las instrucciones siguientes antes de su utilización.Características principales1. Función de prevención de sobrecargas 2. Voltaje internacional de 100 a 240 V de caEste producto está disponible en las series CP-F/CP-V.Componentes Puerto USB Conector USB Conector micro USBCarga1. Conecte el conector micro USB del cable USB suministrado en el puerto de entrada micro USBdel dispositivo portátil.2. Conecte el otro extremo del cable USB suministrado en el puerto USB de la unidad.3. Inserte el enchufe en la toma de corriente.4. Cuando termine de utilizarlo, desconecte el cable USB de la unidad.NotasEl puerto USB de la unidad es únicamente para el suministro de energía. No los conecte a los puertosUSB de los ordenadores, etc., ya que podría provocar un fallo de funcionamiento.La salida de energía USB de este producto es de 2.1 A como máximo. La función de seguridadenergética detendrá el suministro de energía si la salida total es superior a 2.1 A.Si se carga un dispositivo portátil con esta unidad, el tiempo de carga variará en función del estado de labatería de dicho dispositivo.Antes de conectar un dispositivo portátil a la unidad, coloque la batería del dispositivo portátil. Si seconecta un dispositivo portátil mientras se extrae la batería, se podrían ocasionar daños al dispositivoportátil o la pérdida de datos.Se advierte que algunos dispositivos portátiles podrían sufrir pérdidas repentinas de memoria deentrada se usen o no con esta unidad (para obtener más información, consulte el manual del usuariosuministrado con el dispositivo portátil). Antes de utilizar este producto, asegúrese de realizar una copiade seguridad de la memoria de entrada. Sony no es responsable de la pérdida de memoria de entrada.Si no va a utilizar la unidad durante un periodo prolongado de tiempo, almacénela con el cable USBdesconectado.EspecificacionesUnidadEntrada ca de 100 V a 240 V 0.3 A 50/60 Hz 15 WSalida cc de 5 V 2.1 ADimensiones [ULA] 41.0 mm × 61.0 mm × 26.0 mm[AR] 41.0 mm × 61.0 mm × 34.3 mmPeso [ULA] Aprox. 53 g / [AR] Aprox. 60 gTemperatura de funcionamientoDe 0 °C a 35 °CEl diseño y las especificaciones están sujetos a cambios sin previo aviso.Solución de problemasLa unidad no puede suministrar energía a dispositivos portátiles.La conexión de la clavija es deficiente.Limpie la clavija con un paño seco.Conéctela a otra toma de corriente.El entorno de uso se encuentra fuera del rango de temperaturas de funcionamiento.Utilice la unidad en el rango de temperaturas de funcionamiento.La conexión del cable USB entre la unidad y el dispositivo portátil no es correcta.Conecte el cable USB correctamente.El dispositivo portátil no está en modo de carga.Compruébelo y configure el dispositivo portátil en modo de carga.Encienda el dispositivo portátil antes de realizar la carga.No puede conectar el cable USB correctamente.Es posible que haya conectado un cable de un tipo diferente.Utilice el cable USB correcto.Es posible que haya polvo o partículas similares en el puerto USB.Limpie el puerto USB.Si desea realizar alguna otra consulta, póngase en contacto con su distribuidor de Sony o con un centro deservicio técnico autorizado de Sony.AdvertenciaNo provoque un cortocircuito en la unidad. Para evitar que se produzca un cortocircuito, mantenga launidad alejada de cualquier objeto metálico (p. ej., monedas, horquillas, llaves, etc.).La unidad podría calentarse durante la carga. Esto es normal. Tenga cuidado al manejarla.Utilice este producto adecuadamente para evitar descargas eléctricas.PRECAUCIÓNNo deje caer ni coloque peso encima del producto. Asimismo, no proporcione golpes fuertes a dichoproducto.No caliente la unidad ni la arroje al fuego.No desmonte ni vuelva a montar la unidad.----You cannot connect the USB cable properly.You may have connected a different type of cable.Use the correct USB cable.Some dust, etc., may be in the USB Port.Clean the USB port.Contact your Sony dealer or authorized Sony service facility for any further questions.WarningDo not short-circuit the unit. To avoid short-circuiting, keep the unit away from all metal objects (e.g.coins, hair-pins, keys, etc.).The unit may become hot when charging. This is normal. Use caution when handling.Use this product properly to avoid electric shock.CAUTIONDo not drop, place heavy weight on, or allow strong impact to this product.Do not heat the unit or dispose of it in fire.Do not disassemble or reassemble this product.This appliance is not intended for use by persons (including children) with reduced physical, sensory ormental capabilities, or lack of experience and knowledge, unless they have been given supervision orinstruction concerning use of the appliance by a person responsible for their safety.Children should be supervised to ensure that they do not play with the appliance.Do not expose this product to direct sunlight or water.Keep away from high temperatures or humidity.While in use, do not cover this product with materials such as blankets.The contact surface of the unit must always be kept clean.Notes on using this productFor details on operation of the portable device, refer to its user manual. Operation varies depending onthe device.Connect the plug into a wall outlet firmly.Do not touch the unit and the plug with your wet hand.Do not break the plug.Use this product only within the voltage of AC 100 V - 240 V.Do not use or store this product in a humid or dusty place.Place this product in a stable location.Keep clean the plug, inside of the USB port.Do not touch the USB Port directly or insert your fingers into it.While charging, TV, radio or tuner interference may occur. Use the unit away from these products.WARRANTY *For USA only.Our product warranty is limited only to the unit itself, when used normally in accordance with theoperating instructions and the system environment. Therefore, Customer acknowledges and agrees that:Sony is not liable for damage or loss resulting from the use of this product, or for any claim from a thirdparty.Sony is not liable for problems with your MP3 player, cell phone or other hardware arising from the useof this product; the suitability of the product for specific hardware, software, or peripherals; operatingconflicts with other installed software; data loss; or other accidental or unavoidable damages.Sony is not liable for financial damages, lost profits, claims from third parties, etc., arising from the useof this product.Customer ServicePhone: (956) 795-4552 U.S.A.e-mail: snl.service@am.sony.comINTERNET: http://www.sony.com/batteryFor USA onlyLimited Warranty *For USA only.Sony Electronics Inc. (for U.S. purchases) warrants this product (“Product”) against defects in materialor workmanship for one (1) year from original retail purchase and when purchased directly from Sonyor a Sony Retailer. If Sony finds the Product contains any such defect, Sony will either replace theProduct at no charge or, at Sony’s discretion, refund the purchase price shown on your receipt. Toobtain warranty service, you must, during the warranty period, send your defective Product to Sony,postage prepaid, with a letter that includes your name, address and phone number and a description ofthe problem encountered. A dated purchase receipt is required from Sony or a Sony Retailer. Todetermine if a retailer is part of the Sony Retailer Network, please contact Sony’s Customer Service CallCenter or go towww.sony.com/support. In the U.S. and Puerto Rico, call (800) 942-SONY (7669). This warranty isvalid only in the country of purchase.REPLACEMENT OR REFUND OF THIS PRODUCT AS PROVIDED UNDER THIS LIMITEDWARRANTY SHALL BE THE EXCLUSIVE REMEDY OF THE CONSUMER. SONY SHALL NOT BELIABLE FOR ANY LOSS OR DAMAGES, INCLUDING CONSEQUENTIAL, INDIRECT ANDINCIDENTAL DAMAGES, ARISING OUT OF THE USE OF, OR INABILITY TO USE, THEPRODUCT OR FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY OR CONDITION ONTHIS PRODUCT. UNDER NO CIRCUMSTANCES SHALL SONY BE LIABLE FOR AN AMOUNTGREATER THAN THE ACTUAL PURCHASE PRICE OF THE PRODUCT. EXCEPT TO THEEXTENT PROHIBITED BY LAW, ANY IMPLIED WARRANTIES OR CONDITIONS OFMERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED INDURATION TO THE DURATION OF THIS LIMITED WARRANTY.Some states or jurisdictions do not allow limitations on how long an implied warranty or condition lastsor exclusions or limitations of consequential or incidental damages, so the above limitations orexclusions may not apply to you. This warranty gives you specific legal rights, and you may also haveother rights which vary from state to state or jurisdiction to jurisdiction.THIS CLASS B DIGITAL DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICEMAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPTANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSEUNDESIRED OPERATION.Declaration of ConformityTrade Name : SONYModel : CP-AD2Responsible Party : Sony Electronics Inc.Address : 16530 Via Esprillo, San Diego, CA 92127 U.S.A.Telephone Number : 858-942-2230This device complies with part 15 of the FCC rules. Operation is subject to the following twoconditions: (1) This device may not cause harmful interference, and (2) this device must accept anyinterference received, including interference that may cause undesired operation.EnglishIMPORTANT SAFETY INSTRUCTIONS – SAVE THESE INSTRUCTIONS.DANGER – TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,CAREFULLY FOLLOW THESE INSTRUTIONS.For connection to a supply not in the U.S.A., use an attachment plug adaptor of the proper configurationfor the power outlet, if needed.Please read the following instructions carefully before use.Leading Features1. Overcharge prevention function 2. Worldwide Voltage AC 100 V - 240 VThis product can be used with CP-F/CP-V series.PartsUSB portUSB connectorMicro USB connectorCharging1. Connect the micro USB connector of the supplied USB cable to the micro USB Input port of aportable device.2. Connect the other end of the supplied USB cable to the USB port of the unit.3. Insert the plug into the outlet.4. After using, disconnect the USB cable from the unit.NotesThe USB port of the unit is a power supply only. Do not connect to the USB ports of computers, etc.Doing so may cause a malfunction.USB power output of this product is max. 2.1 A. The power safety feature will stop power supply if thetotal output exceeds 2.1 A.When charging a portable device by this unit, charging time will vary depending on the battery status ofthe portable device.Before connecting a portable device to the unit, attach the portable device’s battery pack. Connecting aportable device while its battery is removed may cause loss of data or damage to the portable device.It is cautioned that some portable devices may incur sudden loss of input memory whether or not theyare used with this unit (for details, refer to the user manual supplied with the portable device). Beforeusing this product, be sure to back up input memory. Sony is not liable for loss of memory.If you do not intend to use the unit for long period, store it with the USB cable disconnected.SpecificationsUnitInput AC 100 - 240 V, 0.3 A, 50/60 Hz, 15 WOutput DC 5 V, 2.1 ADimensions 41.0 mm × 61.0 mm × 26.0 mm (1 5/8 inches × 2 3/8 inches × 1 1/16 inches)(W/H/L)Weight Approx. 53 g (1.87 oz)Operating Temperature 32 °F - 95 °F (0 °C - 35 °C)Design and specifications are subject to change without notice.TroubleshootingThe unit cannot supply power to a portable device.There is a bad connection with the plug.Clean the plug with a dry cloth.Connect it to another wall outlet.The usage environment is out of operating temperature range.Use in the operating temperature range.The USB cable between the unit and the portable device is connected incorrectly.Connect the USB cable correctly.The portable device is not in charging mode.Check and set up the portable device in charging mode.Turn the portable device on before charging.USB AC AdaptorOperating InstructionsManual de InstruccionesManual de InstruçõesCP-AD2© 2013 Sony Corporation Printed in China0904-310-02002

/ 2

Related manuals for Sony CP-AD2