Sony CMT-HPZ9 Operating Instructions Manual

Also see for CMT-HPZ9 - Micro Hi Fi Component System: Operating instructions Service manual Installation and operating guide Specifications Limited warranty

To change the AM tuning interval(except for European model)The AM tuning interval is factory-preset to9 kHz (or 10 kHz for some areas). To change tileAM tuning interval, tune in any AM station first.then turn oflthe system. While holding Di>Dt>0.press I/(!) on the unit. When you change theinterval, all the AM preset stations are erased.To reset the interval, repeat the same procedure.NoteYou cannot change the AM tuning interval in Po_erSaving Mode (page 26).Tips• The preset stations are retained for about baH a dayeven if you disconnect the power cord or if a powerl,ulure occurs.• To improve broadcast reception, a_liust the suppliedantennas, or connect a commercially availableexternal antenna.To improve tuner receptionWhen tuner reception is poor. set CD playerpower off by CD power manage function.CD power is factory set to on.Use buttons oll the unit for the operalion.1 Press FUNCTION repeatedly to switch thefunction to CD.2 Press I/@ to turn off the system.3 After "STANDBY" stops flashing, press I/_while holding l"CD POWER" and "OFF" appear.To set CD power onRepeat the procedure above and "CD POWER"and "ON" appear.Notes• When "CD POWER" and "OFF are selected, discaccess time is increased.• You cannot change the sclting in Power SavingMode (page 26).You can lislen to a radio slalion either byselecting a presel station, or by manually luningin lhe slalion.Listening to a preset station-- Preset TuningPreset radio stations in the Iuner's memory first(see "Presetting radio stations" on page 18).1 Press TUNER BAND (or FUNCTIONrepeatedly) to switch the function toTUNER.234Press TUNER BAND repeatedly toselect "FM" or "AM".Press TUNING MODE repeatedly until"PRESET" appears in the display.Press + or- (or TUNE + or- on the unit)repeatedly to select the desired presetstation.continued19G8