Sony CECH-3006A Instruction Manual

3Replacing the hard diskENReplacing the hard diskCautionFor safety reasons, be sure to turn off and unplug the system before attemptingto replace the hard disk.When replacing the hard disk, follow the procedure below to removethe metal frame.1 Using a crosshead screwdriver, remove the screws (4 places).2 Hold the hard disk by the edges, and then turn it over.Grasp firmly by the opening oneither side to prevent slipping.3 Remove the hard disk from the metal frame.4 Place the replacement hard disk on the metal frame for thePS3™ system's hard disk, and then attach using the screws(4 places).Do not overtighten the screws.5 Install the hard disk in the system.Refer to the instructions in "Removing the hard disk" ( page 37) and followthe steps in reverse order when installing. Be sure to fully insert the hard diskin the HDD bay.6 Reinstall the system software.After the hard disk has been replaced, the system software must bereinstalled ( page 40).Replacement hard disksYou can use hard disks of the following types with the PS3™ system.Size 2.5 inch (internal type) *1Interface format Serial ATA *2*1 Proper operation is not guaranteed for all models.*2 Parallel ATA is not supported.

/ 112

This manual is suitable for:

CECH-3006A CECH-3006B CECH-3007A CECH-3007B CECH-3012A CECH-3012B

Sony CECH-3006A Instruction Manual

Product

Learn More

Legal