Sony BKPF-105A Operation Manual

Also see for BKPF-105A: Installation manual

16 (E)BKPF-205/205RGeneralPower requirements +5 V DC: 0.61 A−5 V DC: 0.63 A(supplied from the PFV-D20/D50/D100A/D200A/D300)Power consumption approx. 6.2 WOperating temperature5°C to 40°C (41°F to 104°F)DimensionsBoard: 194 × 310 mm (h/d)(7 3 / 4 × 12 1/ 4 inches)Connector panel: 194 × 75 × 25 mm (h/d/w)(7 3 / 4 × 3 × 1 inches)MassBoard: approx. 530 g (1 lb 3 oz)Connector panel: BKPF-205: approx. 180 g (6.3 oz)BKPF-205R: approx. 160 g (5.6 oz)Inputs/outputsSDI input SDI IN connector (BNC type) (1)Conforms to SMPTE 259M4:2:2 component serialdigital video signal or4fsc NTSC composite serialdigital video signal(selected with an internalswitch)Input impedance 75 ohmsInput return loss 15 dB or more(5 MHz to 270 MHz)Transmission distance200 m max. (when using aBelden 8281 coaxial cable)SDI outputs SDI OUT connectors(BNC type) (2)Serial digital video signal ofthe same format as that to theinput connector0.8 Vp-p±10%, 75 ohmsOutput return loss 15 dB or more(5 MHz to 270 MHz)Analog audio signal inputsANALOG IN AUDIOconnectors (4)BKPF-205: XLR-3-31 (female)BKPF-205R: XLR-3-32 (male)balanced (electronic balance)Input impedance 600 ohms/20 kilohms (selectedwith an internal switch)Reference input level+4 dBm (–10 to +8 dBmcontinuously variable)Conversion characteristicsQuantization 20-bit linear/48-kHz samplingHeadroom 20 dB (at operation level)Frequency response 20 Hz to 20 kHz within dB(at 1 kHz standard)Distortion 0.05% or less (1 kHz, referencelevel, 30 kHz low-pass)Signal-to-noise ratio 95 dB or more (maximum inputlevel, 30 kHz low-pass)Cross talk –90 dB or less (up to 15 kHz)Input signal common-mode rejection ratioMore than 80 dB (at 60 Hz)Phase difference between channelsWithin the same board:0.1° or less (at 1 kHz)Between the cascaded boards:6° or less (at 1 kHz)Multiplex format Conforms to SMPTE 272MSignal delay4:2:2 SDI approx. 0.78 μs4fsc SDI approx. 1.47 μsAnalog audio approx. 1.1 ms (at 4:2:2 SDI)approx. 1.3 ms (at 4fsc SDI)EDH Conforms to SMPTE RP165ISR output informationStatus messages: 5 itemsSetup messages: 8 itemsDesign and specifications are subject to changewithout notice.+0.2–0.3Specifications