Sony BKNW-116 Operation Manual

Also see for BKNW-116: Maintenance manual Installation manual

1(E)WARNINGTo prevent fire or shock hazard, do notexpose the unit to rain or moisture.To avoid electrical shock, do not open thecabinet. Refer servicing to qualifiedpersonnel only.For the customers in USAThis equipment has been tested and found to comply withthe limits for a Class A digital device, pursuant to Part 15 ofthe FCC Rules. These limits are designed to providereasonable protection against harmful interference whenthe equipment is operated in a commercial environment.This equipment generates, uses, and can radiate radiofrequency energy and, if not installed and used inaccordance with the instruction manual, may cause harmfulinterference to radio communications. Operation of thisequipment in a residential area is likely to cause harmfulinterference in which case the user will be required tocorrect the interference at his own expense.You are cautioned that any changes or modifications notexpressly approved in this manual could void your authorityto operate this equipment.The shielded interface cable recommended in this manualmust be used with this equipment in order to comply withthe limits for a digital device pursuant to Subpart B of Part15 of FCC Rules.WARNING: THIS WARNING IS APPLICABLE FOR USAONLY.If used in USA, use the UL LISTED power cord specifiedbelow.DO NOT USE ANY OTHER POWER CORD.Plug Cap Parallel blade with ground pin(NEMA 5-15P Configuration)Cord Type SJT, three 16 or 18 AWG wiresLength Less than 2.5 m (8 ft 3 in)Rating Minimum 10 A, 125 VWARNING: Using this unit at a voltage other than 120Vmay require the use of a different line cord orattachment plug, or both. To reduce the risk offire or electric shock, refer servicing toqualified service personnel.For the customers in the United KingdomWARNINGTHIS APPARATUS MUST BE EARTHED.IMPORTANTThe wires in this mains lead are coloured in accordance withthe following code:Green-and-yellow: EarthBlue: NeutralBrown: LiveAs the colours of the wires in the mains lead of thisapparatus may not correspond with the coloured markingsidentifying the terminals in your plug proceed as follows:The wire which is coloured green-and-yellow must beconnected to the terminal in the plug which is marked by theletter E or by the safety earth symbol Y or coloured greenor green-and-yellow.The wire which is coloured blue must be connected to theterminal which is marked with the letter N or coloured black.The wire which is coloured brown must be connected to theterminal which is marked with the letter L or coloured red.For the customers in EuropeThis product with the CE marking complies with both theEMC Directive (89/336/EEC) and the Low Voltage Directive(73/23/EEC) issued by the Commission of the EuropeanCommunity.Compliance with these directives implies conformity to thefollowing European standards:• EN60950: Product Safety• EN55103-1: Electromagnetic Interference (Emission)• EN55103-2: Electromagnetic Susceptibility (Immunity)This product is intended for use in the followingElectromagnetic Environment(s):E1 (residential), E2 (commercial and light industrial), E3(urban outdoors) and E4 (controlled EMC environment, ex.TV studio).English