Sony BDX-E1000 Installation Manual

2-5 (E)BDX-E10002-4. BDKP-E1004/E1005 InstallationEither BDKP-E1004 (SCR-4 board) or BDKP-E1005(SCR-5 board) can be installed on the SY-240 board whichhas board suffix -13 and higher.Installation procedures1. Remove the SY-240 board from the BDX-E1000.(Refer to the Section 2-1.)2. Fix the two PCB holders supplied with the BDKP-E1004/E1005 to the SY-240 board.3. Match the connectors CN301 and CN302 on the SCR-4/5 board with the connectors CN901 and CN902 onthe SY-240 board.4. Connect the connectors on the SCR-4/5 board to theconnectors on the SY-240 board while inserting thePCB holders through the holes on the SCR-4/5 board.nMake sure that the connectors are connected tightly.5. Insert the SY-240 board into the Slot No.4. (Refer tothe Section 2-1.)6. Install the board retainer with the four screws.7. Close the front panel.8. Tighten the locking screw.Confirmation after installationThere is no necessity to confirm/adjust after SCR-4/5board installing.SY-240 boardPCB holders2-4. BDKP-E1004/E1005 InstallationSY-240 boardSCR-4/5 boardCN902CN302CN301CN901PCB holderPCB holder