Sony BCR-NWU3 Operating Instructions Manual

Also see for BCR-NWU3: Specifications

Contents

connecting to a computer

2-895-765-13(1)CradleOperating Instructions / Mode d’emploi© 2006 Sony Corporation Printed in ChinaBCR-NWU3EnglishWARNINGTo reduce the risk of fire or electric shock, do not expose this apparatus to rain ormoisture.Do not install the appliance in a confined space, such as a bookcase or built-in cabinet.To reduce the risk of fire, do not cover the ventilation of the apparatus with newspapers,tablecloths, curtains, etc. And do not place lighted candles on the apparatus.To reduce the risk of fire or electric shock, do not place objects filled with liquids, suchas vases, on the apparatus.Connect the AC power adaptor to an easily accessible AC outlet. Should you notice anabnormality in the AC power adaptor, disconnect it from the AC outlet immediately.For Customers in the USAThis device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions: (1) this device may not cause harmful interference, and (2)this device must accept any interference received, including interference that maycause undesired operation.You are cautioned that any changes or modifications not expressly approved in thismanual could void your authority to operate this equipment.For Customers in RussiaDisposal of Old Electrical & Electronic Equipment (Applicable in the EuropeanUnion and other European countries with separate collection systems)This symbol on the product or on its packaging indicates that thisproduct shall not be treated as household waste. Instead it shall behanded over to the applicable collection point for the recycling ofelectrical and electronic equipment. By ensuring this product isdisposed of correctly, you will help prevent potential negativeconsequences for the environment and human health, which couldotherwise be caused by inappropriate waste handling of this product.The recycling of materials will help to conserve natural resources. For more detailedinformation about recycling of this product, please contact your local Civic Office,your household waste disposal service or the shop where you purchased the product.The validity of the CE marking is restricted to only those countries whereit is legally enforced, mainly in the countries EEA (European EconomicArea).For customers in the USAUse “LIMITED WARRANTY” card warranted by Sony Electronics Inc.For customers in CanadaUse “Consumer 1 Year Warranty” card warranted by Sony of Canada Ltd.Note on installationIf you use the unit in a place subject to static or electromagnetic energy, a track’stransferred data may be corrupted. This may prevent successful transferringauthorization on your computer.Notes on use• Do not subject the unit to:– Extreme heat or cold – Dust, dirt, or sand– High humidity – Vibration– Strong magnetic fields – Mechanical shock– Direct sunlight (for extended periods)• Do not set the unit on an unstable surface as it may fall, causing injury ordamage.• Do not drop the unit.• Unplug the AC adapter from the AC outlet if the unit is not to be used for anextended period. Disconnect the power cord by the plug, never the cord itself.• Be sure that nothing metallic comes into contact with the metal parts ofthis unit as a short circuit may occur and the unit may be damaged.• Do not operate the unit if it has a damaged cord, or if it has beendropped or damaged.• Always keep the metal contacts clean.• Do not disassemble or modify the unit.• While the unit is in use, it gets warm. This is normal.• Keep the unit away from TV or AM receivers, as it may disturb reception.CleaningClean the unit with a soft, dry cloth, or a soft cloth lightly moistened with amild detergent solution. Do not use any type of solvent, such as alcohol orbenzine, which may damage the finish.PreparationChecking the supplied accessories• Cradle (1) (A)• DC charging cord (1) (B)• AC adaptor (C)• AC power cordChecking other components• WalkmanFor details about series Walkman units supported by the cradle, visit:USA: http://www.sony.com/walkmansupport/Canada: http://www.sony.ca/ElectronicsSupport/Europe: http://www.sonydigital-link.com/DNA/China: http://service.sony.com.cn/KB/Taiwan: http://www.twsupport.css.ap.sony.com/Korea: http://scs.sony.co.kr/walkman/Other countries or areas: http://www.css.ap.sony.com/• Attachment for a Walkman *• USB cable * (D)* The USB cable is required to connect the cradle to your computer. The USBcable is supplied with the Walkman.Installing the attachmentWhen you use the cradle, fit the attachment supplied with your Walkman.To install the attachment, fit the two tabs near the logo into the holes on thecradle first, then push the opposite side down into the cradle.To remove the attachment, push strongly the concave part of attachmenttoward the rear of the cradle 1, then push strongly the area indicated by themark (a a a) from above 2. (E)NoteThe shape of the attachment may be different, depending on your Walkman model.Parts and controlsRefer to Illustration A.1 WM-PORT* connector for Walkman: To connect a Walkman to thecradle.2 AUDIO OUT jack: Outputs a line-level signal to a device such as anactive speaker, using an optional audio cable.3 AUDIO IN jack: Accepts a line-level signal from a music player, such asa CD player, using an optional audio cable.4 LEVEL switch: Sets the recording level.LEVEL[1](recording with the normal volume level): To record from theline out jack or headphone jack of a device such as a portable musicplayer.LEVEL[2](recording with the volume lowered): To record from the lineout jack of a device that has a high sound output level, such as acomponent audio system.(Using LEVEL[1] in this case may result in distortion of the audio signal.)5 WM-PORT jack for a computer: To connect the cradle to your computerusing the USB cable (supplied with the Walkman).NoteIf a device other than a computer is to be connected, refer to the operatinginstructions supplied with the device.6 DC IN jack: To connect the cradle to the AC adaptor (supplied) using theDC charging cord to charge the Walkman.* WM-PORT is a dedicated multiple connector for connecting accessories toyour Walkman.Charging a WalkmanRefer to Illustration F.1 Connect the smaller terminal (7) of the DC charging cord(supplied) to the DC IN jack (8) of the cradle.2 Connect the larger terminal (9) of the DC charging cord tothe AC adaptor (supplied).3 Connect the AC power cord (supplied) to the AC adaptor (q;).4 Connect the AC power cord to the wall outlet (qa).5 Attach the Walkman to the WM-PORT connector on the topof the cradle (qf).Charging starts. Charging time will vary, depending on the model of theWalkman. For details, refer to the Operation Guide of the Walkman.Notes• Place the Walkman firmly into the cradle.• Do not connect anything to the AUDIO OUT jack of the cradle if you listen tosongs using the headphones of the Walkman while charging. Otherwise, nosound is output from the headphone jack of the Walkman.Connecting to a computerRefer to Illustration F.1 Connect the WM-PORT of the USB cable (supplied with theWalkman) to the WM-PORT on the back of the cradle (qs).2 Connect the other end of the USB cable to your computer (qd).3 Attach the Walkman to the cradle (qf).Notes• Place the Walkman firmly into the cradle.• If the cradle is connected to a wall outlet, the Walkman will be charged fromthe wall outlet.• Even if the cradle is not connected to a wall outlet, the Walkman can be charged viathe USB cable. If the cradle is connected to a laptop computer which is not connectedto a wall outlet, the Walkman will deplete the battery of the laptop computer.• A Walkman will not be recognized by a computer if the cradle is connected tothe computer by the DC charging cord.• If the Walkman is disconnected from the cradle while data is being transferredfrom the computer, attach the Walkman to the cradle and transfer the data again.• Do not disconnect the USB cable, DC charging cord and AC power cord whiletransferring data from the computer; otherwise the data transfer will beinterrupted. If this occurs, detach the Walkman from the cradle, and transferthe data after attaching the Walkman to the cradle again.Recording to a WalkmanRefer to Illustration F.By connecting a music player, such as a CD player, to the AUDIO IN jack ofthe cradle by an optional audio cable (qg), you can record to the Walkman*attached to the cradle.* Models that have a WM-PORT and recording functions only1 Connect the music player to the AUDIO IN jack of the cradlewith a suitable audio cable (sold separately).2 Attach the Walkman to the cradle.The recording procedure will vary depending on the model of theWalkman. For details, see the Operation Guide of the Walkman.z HintSound levels during recording can be changed by setting the LEVEL switch. Fordetails, refer to “LEVEL switch” under “Parts and controls”.NoteIf the audio cable is connected to the AUDIO OUT jack, sound during recordingis output from an audio output device, such as an active speaker. If nothing isconnected to the AUDIO OUT jack, sound during recording is output from theheadphone jack of the Walkman.Connecting to a device suchas a speakerRefer to Illustration F.Using an optional audio cable (qh), you can connect the cradle to a devicethat outputs audio, such as an active speaker. Be sure to turn off all devicesbefore connecting them.1 Connect the device to the AUDIO OUT jack of the cradle witha suitable audio cable (sold separately).2 Attach the Walkman to the cradle.3 Start playback of the Walkman.Notes• Connect the audio cable before starting playback on or recording to theWalkman. If you connect it after starting playback, sound may not be outputfrom the AUDIO OUT jack. If this occurs, detach the Walkman from thecradle, and start playback after attaching the Walkman to the cradle again.• While the cradle is connected to the computer, sound may not be output from theAUDIO OUT jack of the cradle. If this occurs, disconnect the USB cable from thecomputer.• Sound from the computer is not output from the AUDIO OUT jack of thecradle.• While the cradle is connected to an audio output device, no sound is outputfrom the headphone jack of the Walkman.• If the recording level of audio data played back on the Walkman is too high, theoutput sound quality from the Walkman via the cradle to a device, such as anactive speaker, may not meet the user customized settings, e.g., “Equalizer” etc.• If you use a Walkman with a built-in FM tuner, you may not be able to hearthe FM broadcast, or reception may be lowered substantially.SpecificationsTerminals WM-PORT connector (22 pin) (For Walkman)WM-PORT jack (22 pin) (For a computer)AUDIO OUT (Stereo mini, 10kΩ)AUDIO IN (Stereo mini), DC IN 5VSwitch settings LEVEL 1/2AC adaptor DC 5V“WALKMAN” and “WALKMAN” logo are registered trademarks of Sony Corporation.AB C DEFqfqa879qdqgqhq;qs12

/ 2

Related manuals for Sony BCR-NWU3