Sony Alpha E 4/PZ 18-110 G OSS Service Manual

Also see for SELP18110G: Operating instructions

5-6SELP18110GPreparations of Using a Camera (General E-mountInterchangeable Lens Digital Camera)Equipment• Camera (General E-mount interchangeable lens digital camera)Preparation1. Attach the E-mount attachment to the A-mount attachment andinstall them to the flange back tester.Note 1: Configure the setting of a camera attached to the E-mount attachment as follows.• Focus Mode: Manual Focus• Shake Compensation: OFF• Aperture: Open2. Attach the extension jig (47.00 mm) to the objective lens (10x)to install it to the flange back tester.3. Attach the checking lens to the flange back tester as shown inthe following figure, and set the 1000 mm collimator.1000 mm collimatorChecking lens Extension Jig (47.00 mm)E-mount AttachmentCamera(General E-mountinterchangeable lensdigital camera)Camera Table200×200FB Tester Stand4. Turn the focus ring of the checking lens while observing themicroscope and stop it at the position where the chart image isin focus.Preparations of Using a B-L Control BoxEquipment• Personal Computer (See Note 1)• B-L Control Box (Supplied with D-sub 15-pin cable)• AC cable (Sold on the market)• RS-232C Cable (D-sub 9-pin (Male with securing screws), D-sub9-pin (Female with securing screws)) Straight type (Sold on themarket)• USB to serial cable (D-sub 9-pin (Male)) (Sold on the market)• Lens adjustment program (BLG-TestProgramV[][][].exe) (SeeNote 2)Note 1: Personal computer must have the condition that WindowsVista/7 runs normally and USB is connectable.Note 2: For adjustment of the SELP18110G, prepare a version 1.0.0.1or higher of the BLG-TestProgram.Preparation1. Attach the E-mount attachment to the A-mount attachment andinstall them to the flange back tester.2. Attach the extension jig (47.00 mm) to the objective lens (10x)to install it to the flange back tester.3. Attach the checking lens to the flange back tester as shown inthe following figure, and set the 1000 mm collimator.1000 mm collimatorChecking lensExtension Jig (47.00 mm)E-mount AttachmentUSB to Serial CableD-sub 9-pin: FemaleRS-232C CableAC CableD-sub 9-pin:MaleB-L Control BoxPersonal computerD-sub 15-pincableCamera Table200×200FB Tester Stand4. Install the BLG-TestProgram in the following procedure.(1) Download the file “BLG-TestProgramV[][][].zip”, save andextract it.(2) Save “BLG-TestProgramV[][][].exe” in an arbitrary folder.– Continued on next page –