41AVD-K150B/K150E/K150G/K150N/K150RPurpose:To determine if the Mechanism is in the correct position, when a Tape is ejected.1. Mechanism Alignment Position Check1) Turn the Power S/W on and eject the Cassette by press-ing the Eject Button.2) Remove the Top Cover and Plate Assembly Top, visual-ly check if the Gear Cam Hole is aligned with theChassis Hole as below Fig. C-2.3) IF not, rotate the Shaft of the Loading Motor to eitherclockwise or counterclockwise until the alignment is asbelow Fig. C-2.4) Remove the Screw which fixes the Deck Mechanism andMain Frame and confirm if the Gear Cam is aligned withthe Gear Drive as below Fig. C-1(A).5) Confirm if the Mode S/W on the Main P.C.Board isaligned as below Fig. C-1(B).6) Remount the Deck Mechanism on the Main P.C.Boardand check each operation.Gear CamGear Drive(A)Mode S/W(B)L/D Motor AssemblyGear CamChassis Hole Gear Cam Hole(A)(B)(A')(B')Gear Drive HoleTest Equipment/ Fixture• Blank tapeTest Conditions (MechanismCondition)• Eject Mode (with Cassette ejected)Check Point• Mechanism and Mode Switch PositionFig. C-1Fig. C-2CHECK DIAGRAMBOTTOM VIEWTOP VIEWGear Cam (o) and Gear Drive (o) groove alignment
