Chapter 1 Overview28 Chapter 1 OverviewLocation and Function of PartsDXF-701WS/701WSCE ViewfinderSHUTTER GAIN UPTAKE BATTRECTALLY1 BATT indicator2 TAKE/TALLY indicator3 REC/TALLY indicators4 SHUTTER indicator5 GAIN UP indicator6 Eyepiece focusing knob7 Accessory fixing screw hole8 Tally lamp9 Eyepiece release catch0 BRIGHT control!¡ CONTRAST control!™ PEAKING control!£ TALLY switch!¢ Viewfinder connectorMicrophone holding screwMicrophone holderMicrophone a)Eye cupa) Not supplied with the optional DXF-701WS/701WSCE1 BATT (battery) indicator (red)This indicates when the battery capacity is low.2 TAKE/TALLY indicator (orange)When using the ClipLink function while shooting, thisindicator lights when the TAKE button (6 on page11) has been pressed to set a Mark IN point and goesout when a Mark OUT point is set.NoteYou can switch the scan size of the DXF-701WS/701WSCE in accordance with the aspect ratioselected on the camera or camcorder. However, itoperates in 4:3 mode when used on the DSR-300/300P.3 REC/TALLY (recording/tally) indicators (red)• From the time when you press the VTR button (9 onpage 11 and !∞ on page 27) on the lens orcamcorder, this flashes until recording starts, thenstays on continuously during recording.• This is also used to indicate a fault. (See page 115.)• The lower indicator can be disabled by menu setting.(See page 86.)
