Sony 1080i Operating Instructions Manual

Also see for 1080i: Operating guide Operating guide Operating guide Operating guide Operating instructions

Contents

8 Chapter 1 OverviewChapter 1 OverviewLocation and Function of PartsFront Panel1 1 (on/standby) switch/ 1 (on/standby) lampPress this switch to turn the unit on. The 1 on/standbylamp lights up in green.2 Remote sensor3 PHONE LEVEL control knobControls the volume of the headphones connected intothe PHONES jack 4.4 PHONES jackConnect stereo headphones for monitoring soundsduring the recording or playback. The audio signal youwant to monitor can be selected in [AUDIO MONI] onthe [AUDIO SET] menu. (p. 47)5 LCD (Liquid Crystal Display) monitorDisplays the playback or EE 1) pictures. Also,superimposed time data, status information, menus,audio level meters, etc. are displayed.6 Operation panel1 1 (on/standby) switch/1 (on/standby) lamp2 Remote sensor3 PHONE LEVEL control knob4 PHONES jack5 LCD monitor6 Operation panel1 Indicator section(see page 8)2 Tape transport controlsection(see page 13)........................................................................................................................................................................................................1) “EE” stands for “Electric to Electric.” In EE mode, the video and audio signals input to the VCR’s recording circuitry donot pass through any magnetic conversion circuits but output via electric circuits only. This mode is used to check the inputsignals and adjust input levels. The pictures output in EE mode are referred to as EE pictures.1 Indicator section1 q (cassette) indicator2 CHG (charge) indicator3 50 indicator4 60 indicator5 HDV indicator6 DVCAM indicator7 HDV-i.LINK indicator8 DV-i.LINK indicator