Siemens iQ500 WT47R461ES Installation And Operating Instructions Manual

en Help with the appliance383 Help with the applianceHel pwi ththeappl i anceFaults Cause/RemedyAppliance does not start. Check the mains plug and the fuses.Creasing. ■ Load exceeded or incorrect programme selected for a type of fabric.All the required information can be found in the programmetable.~ Page 20■ Remove laundry from the drum as soon as the drying programmehas finished. Creasing occurs when clothing is left in the drum.Water is leaking out. ■ The appliance may be positioned at an angle. Level the appliance.■ In the base unit, make sure that:– The heat exchanger cover is properly locked.– There is no dirt or debris on the heat exchanger cover's seal.~ Page 34■ If the optional drain hose* is installed, make sure that the drain hoseis correctly connected. ~ Page 31The appliance is paused but thedrum is turning.The appliance has detected a high temperature and has started theCoolDown process. Temperature regulation can take up to 10 minutes.You can cancel the CoolDown process at any time by opening the door.The programme does not start Make sure that:■ The door is closed■ The w 3 s. (Child Lock) has been deactivated■ You have pressed ‹ inicio/pausa+carga (Start/Reload)Note: If the programme has been delayed by setting termin. B (ReadyIn), the programme starts at a later point.Programme duration displayedchanges as drying progresses.Not a fault. The moisture sensor measures the residual moisture in thelaundry and adjusts the programme duration (with the exception of timedprogrammes).Laundry is not dried properly oris still too damp.■ After the programme has ended, warm laundry feels damper than itactually is. Spread out the laundry and let it cool down.■ Adjust the drying time or increase the degree of dryness. This willextend the drying time but the temperature will remain the same.■ Select a timed programme to add extra drying time for laundry that isstill damp.■ Select a timed programme for a small load.■ Do not exceed the maximum load for a programme.~ Page 20■ Clean the moisture sensor in the drum. The sensor may become cov-ered in a fine layer of limescale or detergent and care product resi-due, which then impairs its performance.~ Page 34■ Drying has been interrupted as a result of a power cut, because thecondensation container is full or because the maximum drying timehas been exceeded.Note: See also the laundry tips.~ Page 23