Siemens Synco 700 Series Basic Documentation

Also see for OZW775: Installation instructions

33/120Building Technologies Basic documentation: Communication via the KNX bus CE1P3127enHVAC Products Device addresses via ACS 30.08.20075 Device addresses via ACS5.1 Service tool OCI700.1 and ACS7… software5.1.1 OverviewThe OCI700.1 service tool is used for commissioning and diagnostics for devices inthe Synco, SIGMAGYR and ALBATROS ranges, and for the operation of plant viathe KNX bus or Local Process Bus (LPB) (see data sheet N5655).When ordering, please use type code OCI700.1. No license is required foroperation. The tool is supplied as a complete kit in a service case:• CD-ROM with− Operating software− Service software− Documentation• OCI700 service interface• USB cable, Type B socket• KNX service cable, RJ45 For Synco devices• LPB service cable, RJ12 For SIGMAGYR and ALBATROS controllers(not illustrated below)The OCI700.1 service tool/ACS7… software are installed on a PC/laptop from theCD-ROM. See data sheets N5640 and N5641 for details of the ACS7… software.The OCI700 service interface converts the signals between the USB port on thePC/laptop and the tool interface on the bus device (RJ45 connection).There is no need to set parameters for the service interface. Only the central unit(OCI700-KNX, see section 5.1.2) needs to be selected via the software, after whichcommunication is established with the device (and other devices on the bus).RM.. QAW740 RXBUSB3127Z32enKNX service cablePC withACS softwareServiceinterfaceRJ45connectorBusconduit boxService tool OCI700.1Installing the softwareOCI700 service interface