Siemens Simatic Net Assembly Instructions Manual

Also see for SIMATIC NET: Operating instructions User manual Installation instructions Manual Configuration manual

Montageanleitung für / Assembly Instructions for SIMATIC NET IE FC RJ45 Plug 180 6GK1901-1BB10-2AxxCopyright © 2017 Siemens AG1. Use the green knife cassette6GK1901-1GB01 (5.1 mm knife clearance)in the stripping tool.If your stripping tool was supplied with ayellow knife cassette, the cutting depth mustbe adjusted with the middle socket-headscrew after fitting the new cassette!2. Take the stripping tool in your right hand.3. Measure the cable length against themeasuring template. Use your left indexfinger as the limit stop.4. Insert the cable into the stripping tool. Yourleft index finger is the limit stop.5. Tighten the stripping tool fully.6. To strip the insulation, turn the tool in thedirection of the arrow- approx. 4 times for PVC insulation,- approx. 8 times for PUR insulation.7. Keeping the stripping tool closed, pull it offthe end of the cable along with the jacketand remnants of the shield.8. If the white filler is not removed with theinsulation, remove it and the transparentprotective foil with your hand.9. Cut off the dummy cores.10. Spread out the wires according to thecolor markings on the contact elements ofthe connector.11. Make sure to observe a length ofapproximately 18 mm.12. Open the holder cover (e) until it latchesand push in the wires according to theircolor coding* as far as the limit stop inthe holder cover13. Push the cable into position as shown inthe picture (see arrows). Press down thecontact elements as far as the limit stopto contact the wires.14. Make sure the length of the corescorresponds to the dimensions stated inthe assembly instructions for therespective plugs.15. Close the cover by pressing together thetwo halves of the lock. In doing so, makesure not to exert pressure on or damagethe latch spring.16. Turn the locking mechanism with yourhand as far as possible in the directionof the arrow.17. Insert a 2.5 mm screwdriver into the holein the locking mechanism and turn it asfar as the limit stop.18. The connector is correctly locked whenthe opening of the locking mechanism ispointing to the side and the surfaces areflush with the surface of the connector.19. Releasing the plugInsert the plug into the socket and pushthe spring down to unlock the plug andrelease it from the socket again.If space is limited, release the plugusing a screwdriver (2.5 mm-wideblade).green51890o38mm