Siemens SN66T094GB Operating Instructions Manual

Also see for dishwasher: Instructions for use Operating instructions Operating instructions Operating instructions Operating instructions

en8As soon as the rinse-aid refill indicator Pis lit on the fascia, there is still a rinse-aidreserve of 1 – 2 rinsing processes. Refillwith rinse aid.The rinse aid is required for stain-freeutensils and clear glasses. Use only rinseaid for domestic dishwashers.Combined detergents with rinse-aidcomponent may be used up to a waterhardness of 21° dH (37° fH, 26° Clarke,3.7 mmol/l) only. If the water hardness isover 21° dH, rinse aid must be used.– Open the dispenser 9* by pressingand lifting the plate on the cover.– Carefully pour rinse aid up to the max.mark in the filler opening.– Close cover until it clicks shut.– To prevent excessive foam formationduring the next rinse cycle, remove anyrinse aid which has run over with acloth.Setting amount of rinse aidThe amount of rinse aid can be set from§:‹‹ to §:‹‡. Please set rinse aid on§:‹† to obtain very good drying results(§:‹† is already set in factory).Change this setting, only if streaks (selectlower setting) or water stains (select highersetting) are left on the utensils.– Open the door.– Switch on ON/OFF switch (.– Hold down programme button # andpress START button )" until •:‹.... isindicated on the digital display.– Release both buttons.The LED for button # flashes and thedigital display 8 displays the factorysetting •:‹….– Press programme button # until thefactory set value §:‹† is indicated onthe digital display 8.To change the setting:– Press programme button 3.Each time the button is pressed, theset value increases by one level; whenthe value of §:‹‡ has been reached,the display jumps back to §:‹‹ (off).– Press START button )".The set value is saved.– Close the door.Switching off rinse aid refillindicatorIf the rinse-aid refill indicator P isimpaired (e.g. when using combineddetergents containing rinse aidcomponent), it can be switched off.– Proceed as described under “Settingamount of rinse aid” and set the valueto §:‹‹.The rinse aid refill indicator P is nowswitched off.Rinse aid %