Siemens SIPROCESS GA700 Quick Start Manual

Also see for SIPROCESS GA700: Compact operating instructions Quick start Operating instructions Operating instructions Compact operating instructions

NoteAuthorization levelTo execute the actions described below, you must be logged on with at least the "Expert"authorization level. You may have to log on again with the requested PIN.NoteAlarm windowWhen you change the hardware of the device by replacing or adding modules or components,the alarm window "Device configuration changed" is displayed in the LUI during re-commissioning. To start the data synchronization, confirm the alarm by pressing .Depending on the specific application, parameter sets may have to be transmitted. Themessage window "Transmit parameters" is displayed. Information on the further procedure isavailable in the tables below:→ Case differentiations (Page 34)→ Case differentiations (Page 34)→ Case differentiations (Page 34)→ Case differentiations (Page 34)→ Case differentiations (Page 34)3.4.3 Case differentiationsTable 3-4 Plug & Measure - CommissioningCase Description Data synchronization/ActionPM AMxNew New Commissioning, PM without serial num‐berAutomatic data synchronization.New New Commissioning, each module has a se‐rial number stored at the factory.None of the modules has been connec‐ted to another module beforeAutomatic data synchronization.Combination operation3.4 Plug & Measure: Permissible activitiesQuick Start34 Compact Operating Instructions, 05/2015, A5E31805656-03