Siemens SINUMERIK FM-NC Installation And Startup Manual

Also see for SINUMERIK 810D: Programming manual Programming manual Programming manual Function manual Function manual

Contents

803.968.1 Alarm and message texts8-194  Siemens AG 2000 All Rights ReservedSINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 EditionThe associated text is given in inverted commas with the position parameters. The characters ” and # must not be used in alarm texts.The character % is reserved for displaying parameters. If the user wishes to use an existing text, a reference to the appropriatealarm text can be inserted. 6-digit alarm number instead of “text”. The alarm text file may contain comment lines which must start with “//”. Themaximum length of the alarm text is 110 characters for a 2-line display. If thetext is too long, it is cut off and the symbol “*” added to indicate missing text. Parameter “%K”: Channel number (2nd digit of alarm number)Parameter “%A”: The parameter is replaced by the signal group no. (e.g.axis no., user area no., sequential controller no.)Parameter “%N”: Signal numberParameter “%Z”: Status numberText or alarm number8 Alarm and Message Texts