| 
Machine the workpiece4.13 Displaying the program runtime and counting workpiecesUniversalOperating Manual, 03/2010, 6FC5398-6AP10-4BA0 117Displayed times● ProgramPressing the softkey the first time shows how long the program has already been running.At every further start of the program, the time required to run the entire program the firsttime is displayed.If the program or the feedrate is changed, the new program runtime is corrected after thefirst run.● Program remainderHere you can see how long the current program still has to run. In addition, you cantrack how much of the current program has been completed as a percentage by using theprogress bar.The display only appears when the program is run a second time.If you are executing the program from an external location, the program loading progressis displayed here.● Influencing the time measurementThe time measurement is started with the start of the program and ends with the end ofthe program (M30) or with an agreed M function.When the program is running, the time measurement is interrupted with CYCLE STOPand continued with CYCLE START.The time measurement starts at the beginning with RESET and subsequent CYCLESTART.The time measurement stops with CYCLE STOP or a feedrate override = 0.Counting workpiecesYou can also display program repetitions and the number of completed workpieces. For theworpiece count, enter the actual and planned workpiece numbers.Workpiece countCompleted workpieces can be counted via the end of program command (M30) or an Mcommand.Procedure1. Select the "Machine" operating area.2. Press the key. |
