Siemens SINUMERIK 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

Contents

Program management13.14 Setup dataMilling570 Operating Manual, 09/2011, 6FC5398-7CP40-2BA013.14 Setup data13.14.1 Backing up setup dataApart from programs, you can also save tool data and zero point settings.You can use this option, for example, to back up tools and zero point data for a specificmachining step program. If you want to execute this program at a later point in time, you willthen have quick access to the relevant settings.Even tool data that you have measured on an external tool setting station can be copiedeasily into the tool management system using this option.Backing-up job listsIf you wish to backup a job list, which contains ShopMill and G code programs, you obtaindedicated selection boxes to backup the tool data and zero points.NoteBacking up setup data from part programsSetup data from part programs can only be backed up if they have been saved in the"Workpieces" directory.For part programs, which are located in the "Part programs" directory, "Save setup data" isnot listed.Backing up dataDataTool data • No• All used in the program (only for ShopMill program and joblist with ShopMill programs)• Complete tool listTool data for ShopMill programs-- only available for job list withShopMill and G code programs• No• All used in the program• Complete tool listTool data for G code programs-- only available for job list withShopMill and G code programs• No• Complete tool listMagazine assignment • Yes• No