Siemens SINUMERIK 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

The feedrate/rapid traverse override is in effect.NOTICERisk of collisionWhen repositioning, the axes move with the programmed feedrate and linear interpolation,i.e. in a straight line from the current position to the interrupt point. Therefore, you must firstmove the axes to a safe position in order to avoid collisions.If you do not use the "Repos" function and subsequently move the axes in manual mode aftera program interrupt, the control automatically moves the axes during the switch to automaticmode and the subsequent start of the machining process in a straight line back to the pointof interruption.PreconditionThe following prerequisites must be met when repositioning the axes:● The program execution was interrupted using .● The axes were moved from the interrupt point to another position in manual mode.Procedure1. Press the key.;=2. Select the axes to be traversed one after the other.3. Press the <+> or <-> key for the relevant direction.The axes are moved to the interrupt position.6.7 Starting execution at a specific point6.7.1 Use block searchIf you would only like to perform a certain section of a program on the machine, then you neednot start the program from the beginning. You can also start the program from a specifiedprogram block.Machining the workpiece6.7 Starting execution at a specific pointGrindingOperating Manual, 05/2017, A5E40869190 125