Siemens SINAMICS Configuration Manual

Also see for SINAMICS: List manual Operating instructions Equipment manual Quick install guide Quick install guide

Contents

Table A-43 Class AttributeNo. Service Type Name1 get UINT16 Revision2 get UINT16 Max Instance3 get UINT16 Num of InstancesTable A-44 Instance AttributeNo. Service Type Name Value/explanation1 get UNIT32 Status Fixed value: 1 hex1: Configuration acknowledged, by DHCP or savedvalues2 get UNIT32 Configuration Ca‐pabilityFixed value: 94 hex4 hex: DHCP supported,10 hex: Configuration can be adjusted,80 hex: ACD-capable3 get, set UNIT32 ConfigurationControl1 hex: Saved values3 hex: DHCP4 get UNIT16 Physical Link Path Size (in WORDs)Fixed value: 2 hexUNIT8 Path20 hex,F6 hex,24 hex,05 hex, where 5 hex is the number of instances ofF6 hex (four physical ports plus one internal port).5 get, set STRING Interface Configu‐rationr61000 Name of StationUNIT32 r61001 IP address6 get, set UNIT16 Host Name Host Name LengthSTRING ‑10 get, set UNIT8 Select ACD local OM flash:0: Disabled,1: Enabled11 get, set UNIT8 Last Conflict De‐tectedlocal OM flash ACD ActivityUNIT8 local OM flash Remote MACUNIT8 local OM flash ARP PDULink Object, Instance Number: F6 hexSupported servicesClass ● Get Attribute all● Get Attribute singleInstance ● Get Attribute all● Get Attribute single● Set Attribute singleCommunicationA.1 CommunicationIndustrial Security198 Configuration Manual, 08/2017, A5E36912609A