Siemens SIMATIC Ident RF200 Operating Manual

Also see for SIMATIC RF200: System manual System manual System manual System manual

AppendixA.3 Wide-range power supply unitASCII protocol for RF200Operating Manual, 11/2016, C79000-G8976-C329-04 43A.3 Wide-range power supply unitThe wide-range power supply unit for SIMATIC RF systems is a universal compact powersupply and allows an efficient, cost-saving solution for many different mid-range powersupply tasks.The primary switched power supply is designed for use on single-phase AC systems. Thetwo DC outputs (sockets) are connected in parallel and protected by a built-in current limitingcircuit against overload and short-circuits.The device is vacuum-cast and prepared for Safety Class I applications. The EU and UKversions satisfy the low-voltage directive as well as the current EU standards for CEconformity. Furthermore, the US version has been UL-certified for the US and Canada.Wide-range power supply unit for SIMATIC RF systems CharacteristicsApplication Supplying power to Siemens IdentdevicesDegree of protection IP67Design features • Mechanically and electrically rug-ged design• Short-circuit and no-load stability• Suitable for frame mountingStructure ① Network connector (PE)② DC output 1③ DC output 2Table A- 1 Ordering data for the wide-range power supply unit for SIMATIC RF systemsArticle numberWide-range power supply unit for SIMATIC RFsystems(100 - 240 VAC / 24 VDC / 3 A)with 2 m connecting cable with country-specific power cable/plug,2 mEU: 6GT2898-0AC00UK: 6GT2898-0AC10US: 6GT2898-0AC20NoteCountry-specific adaptation of the connectorWhen necessary, the primary cable can be adapted to country-specific conditions. Theconnector can be replaced by a country-specific connector. If you do this, make sure that theprotective conductor is in the connector and that grounding is ensured.

/ 46

Related manuals for Siemens SIMATIC RF200